answersLogoWhite

0


Best Answer

A 96 Chevy Beretta Z26 has a 3100 V6 engine. The oil drain is located on the bottom of the oil pan, on a slight angle pointing down and towards the rear.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the engine block drain plug located on a 1996 Chevy Beretta Z26 besides just on the bottom?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the water pump located on a 1991 Chevy beretta?

On the front left of the engine.


Where is the oil pan located on a 1994 Chevy beretta?

Underneath the engine block.


Removing the engine from a 1994 Chevy Beretta- does it come out the top or the bottom of the car?

It comes out the top.


Where is the coil ignition located for 1991 beretta 3.1?

front of engine block right next to the starter.


Were is the oilpan located on a 2007 F-250?

oilpan on any engine is located at the bottom of the engine. it is the most lowest part of an engine, it bolts onto the bottom of the engine block


Why does the oil pressure in a 90 Chevy Beretta drop to 0 when the engine warms up?

it may be the oil pressure sender located on the engine


Where are the 2 crank sensors located on a 95 Beretta?

I have a 92 beretta with a 3.1 litre engine. Just changed crank sensor. Didn't know there were two of them. As far as I know there is only one. It's located on the rear of the engine. Bout a inch above the oil pan. Extremely hard to see.


Will a 3.8 liter engine fit in a beretta?

Naming the 3.8 engine and giving year of 'beretta' would certainly help.


Where is Infiniti qx56 engine number located?

bottom right engine sump


Where is the oil drain plug on a 1993 ford escort located?

The drain plug is located on the bottom of your engine on the oil pan. That should be about in the middle of the engine on the very bottom


Where is the crankshaft located on the 2001 Chrysler sebring convertible limited located?

The crankshaft is the largest part in the bottom of the engine.The crankshaft is the largest part in the bottom of the engine.


Will a 2.8 engine from a 1988 Chevy beretta fit a 1989 Chevy blazer?

Yes it will, but you have to put all the blazer engine stuff onto the beretta engine...