Auto Parts and Repairs
Chevy Blazer S-10
Ford Expedition Eddie Bauer

Where is the engine coolant sensor in a 1998 Saturn SC1?


Top Answer
User Avatar
Wiki User
2005-01-10 13:41:56
2005-01-10 13:41:56

I believe it is on the block where your engine coolant runs into the block from the radiator. There should be two wires that run to a plastic-like sensor.


Related Questions

Engine Coolant Temperature Sensor.

It should be on the right hand side.

where is the engine coolant temperature sensor- low input locationon a 1998 ford taurus

The coolant temperature sensor in a 1998 Cadillac Seville STS is in the engine compartment. It is located on the intake manifold.

Coolant Recovery Reservoir. There is no sensor in the coolant recovery tank on a 1998 Buick Regal.

The coolant temp sensor screws into the thermostat housing. This is located where the top radiator hose connects to the engine.

The coolant level sensor on a 2.4 L is under front of the coolant reservoir towards the engine. It has a 2-wire connector on it.

Either coolant is low or the sensor in the reservoir is stuck with dirt. Clean the reservoir with soap and water

The coolant temperature sensor is located under the hood of the car. The sensor is located to the left of the brake booster at the rear of the engine.รŠ

the fans are operated by means of a series of relays which are turned on or off by the engine computer. the engine coolant temp sensor that sends its signal to the engine computer is what indirectly turns on the fans. if there is no check engine light for a coolant temp. sensor code, the problem lies in the fans themselves, or the relays and related wiring.

I have a 1998 Pontiac Grand AM GT that coolant sensor went bad. So how do you change it with out breaking the coolant

One sensor would be for your engine temperature gauge and the other sensor for the OBD II engine management system

if you are referring to the engine coolant level sensor located in the top of the engine coolant reservior (usually gives the message "coolant sensor bad" in the VIC when it is bad), it can be easily "popped" out of the bottle with no tools necessary and a new one "popped" back in its place. **mine is a V8 model this should hold true for the I6 as well

The coolant temperature sending unit (sensor) is located at the front of the engine, next to or very near the thermostat. Be prepared for some coolant spillage and remember to wrap the threads of the new sensor with teflon tape to prevent leaks. Good luck!

There is NOT a choke on any fuel injected engine. The coolant temperature sensor does the job of what used to be the choke. When the coolant in the engine is cold, the coolant temperature sensor tells the engine control module and it determines how rich or lean to make the engine run. You can use a scanner to see if it and all the other sensors are doing the job they are meant to perform.

Where is the coolant temp sensor on the 1998 gmc safari awd

The computer uses the coolant temp sensor which is located near where the upper radiator hose hooks to the engine.

The coolant temperature sensor on a 1998 Honda Accord is located next to the thermostat housing. The sensor has a blue clip located on the right side of the engine compartment.

on top of the engine in the back " not for beginings" the upper intake must be removed!

Assuming this is the 4.3 engine, the ECT (Engine Coolant Temperature) sensor is located on the driver side cylinder head between #3 and #5 spark plugs.

Trouble code P0118 means: Engine Coolant Temperature Circuit High Input Replace the coolant temp sensor

The coolant temperature sensor is next to the thermostat housing, behind and under the alternator.

its right next to the valve cover on the driver side behind the coolant sensor

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.