answersLogoWhite

0


Best Answer
Copy

the ets button should be locater right on the side of the shifter. i know for a fact on a 97 2.2L sunfire automatic tranny.

User Avatar

Wiki User

โˆ™ 2008-09-03 23:51:49
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +5 pts
Q: Where is the ets switch located?
Write your answer...
Submit

Related Questions

ETS light comes on when the switch located on the side autmatic shifter is pushed 1999 Sunfire 2.2?

It is supposed to. ETS (Enhanced Traction System) is turned on and off with that switch. Leave it on. The system is on and working when the light is off.It is supposed to. ETS (Enhanced Traction System) is turned on and off with that switch. Leave it on. The system is on and working when the light is off.


How do you turn on the ETS on a Pontiac Sunfire?

if it has ets its a thumb switch on the shifter if it is displayed on the cluster its off if not it's on or not equiped


Ets off how do I turn it on?

ok. see the button with the wheels on it near the dimmer switch. It says ETS on it. push and it will light up.


Where are ETS enzymes located in the mitochondria?

inner membrane


Should the ETS System on a 2001 Pontiac Sunfire be on or off?

If your ETS light is on you may want to take a look a your brakes. If your brakes are making a noise, then the sensor has tripped your ETS sensor. Your ETS light is just like the ABS in most vehicles, it means there is a brake problem. Usually it means it is time to change them. The ETS should be off unless there is an electrical problem in the switch (located on the autmatic shifter on some models), or some other electrical problem somewhere else that is causing it to read as off by the computer.


What does ETS mean on a 2002 Grand Am GT?

ETS on a GT means Enhanced Traction System (ETS) or Traction Control.


What is the meaning of ETS in the US Military?

ETS is Expiration Term of Service.


Where is the ETS switch on a 1997 Pontaic Sunfire?

I have a 1998 Pontiac sunfire gt and it is on the side of the gear shifter (automatic) however, if it is standard then I am unsure.


How can you turn the ets on and off?

In some cases you can disconnect the plug on the ebrake switch. I was able to access it by pulling back on the ebrake side cover.


What makes the mercdez Benz e320 ets traction to lose support?

Sounds like it could be the brake lamp switch. That's what it was on mine.


Should you have your ETS light on while driving in winter?

Normally the (Electronic Traction Control) ETS light is on when the ETS is turned off. Make sure the ETS is on and not off when driving at all times winter or summer.


Why does the ets light stay on in car?

Probably because you have the ETS turned off.


When was Marie Hall Ets born?

Marie Hall Ets was born in 1895.


When did Marie Hall Ets die?

Marie Hall Ets died in 1984.


When was University - ETS - created?

University - ETS - was created in 1992.


When was Stadium - ETS - created?

Stadium - ETS - was created in 1978.


Where is the neutral switch located on a 1994 ford escort?

the switch is located in or on the transmission case


How long do you have after you ets to have the army move your household goods?

6 Months after your ETS date.


What does ETS stand for?

ETS stands for Enhanced Traction System. This is GM's version of Traction Control.


1988f150 cluch safety switch were is it located?

safety switch is located under dash on clutch pedal


Where is the flasher module in a Ford Focus located?

It is located underneath the hazard switch, as it is incorporated with the hazard switch.


Where is the oil pressure switch located on a Nissan Largo?

The oil pressure switch is located next to the engine.


What is Enhanced Traction System?

"From the Service Manual: Enhanced Traction System (ETS) The Enhanced Traction System (ETS) is designed to limit wheel slip during acceleration. This objective is accomplished by cutting fuel to selected cylinders, retarding spark and upshifting the transmission. The EBCM monitors wheel speed slip through the ABS wheel speed sensors and determines the desired torque reduction needed to minimize wheel spin. The torque reduction the EBCM requests may result in a combination of fuel cutoff, spark retard, and upshifting the transmission, depending on the torque reduction required. This request is sent from the EBCM through the serial data link to the Powertrain Control Module (PCM). The PCM then calculates and employs fuel cutoff and spark retard values to achieve the requested engine torque. If the EBCM determines that the engine torque reduction is not sufficient to minimize wheel spin, it will request a transmission upshift. The ETS will be enabled when the ETS switch is in the ON position (TRAC OFF indicator not illuminated), the engine coolant temperature is within normal operating range and the manifold air temperature is within normal operating range. There are a number of reasons that the ETS will be inhibited or disabled. * INHIBITED: Not all modes of ETS are available. i.e.: no spark retard, but transmission upshifts are still available. * DISABLED: No ETS modes are available Some of the items that can inhibit or disable ETS are: * ETS OFF switch is in the OFF position. (Disabled) * EBCM senses a valid brake switch input. (Disabled) * Park brake is engaged. (Disabled) * Catalytic converter temperature rises above the normal operating range. (Inhibited) * Engine coolant temperature is not within normal operating range. (Inhibited) * Manifold air temperature is not within normal operating range. (Inhibited) * PCM sets a DTC that turns on the CHECK ENGINE lamp. (Inhibited or Disabled) * PCM sets a Failure Record that does NOT turn on the CHECK ENGINE lamp. (Inhibited or Disabled) * EBCM sets a DTC C1221, C1222, C1223, C1224, C1225, C1226, C1227, C1228, C1232, C1233, C1234, and/or C1235 (any wheel speed sensor DTC). (Disabled) Refer to Self-Diagnostics for more information. ETS OFF Switch The ETS OFF switch is a momentary contact switch. The ETS OFF switch enables or disables the enhanced traction system. When the EBCM needs to illuminate the TRAC OFF or LO TRAC indicators, it will transmit a signal (via serial data link) to the Electronic Instrument Panel Cluster (IPC) and the IPC will illuminate the indicator. The amber TRAC OFF indicator will be illuminated when ETS is disabled or when the driver switches ETS off with the ETS OFF switch. As a bulb check procedure, the EBCM will command the ETS indicator ON for 3 seconds when the EBCM receives power (ignition in ON position). With the ignition in the OFF or START positions (loss of serial data), the IPC will illuminate the ETS OFF indicator lamp. The amber LO TRAC indicator will be illuminated to alert the driver of a low traction situation and to inform the driver the ETS is operating. As a bulb check procedure, the EBCM will command the LO TRAC indicator ON for 3 seconds when the EBCM receives power (ignition in ON or START positions). With the ignition in the OFF position (loss of serial data), the IPC will illuminate the LO TRAC indicator. " The above information was found in http://www.gaownersclub.com/forum/showthread.php?s=0e40c3fe48fba12fdcf38f4fbbf2a878&threadid=92&goto=nextoldest


Why are Ets and engine light on in 98 Chevy cavalier?

Why are ets and engine light on in 98 Chevy cavalier


When you ETS from the army will you be able to take permissive TDY if your married?

yes 10 for ets 20 for retirement