0
Where is the fill hole located on the 1995 lebaron convertible hydraulic motor?
Wiki User
∙ 2009-05-31 23:57:32
there is a rubber plug on the top portion of the motor .remove the plug,fill and put plug back on
Wiki User
∙ 2009-05-31 23:57:32
Add your answer:
Earn +20 pts
How do you take out the motor of a convertible?
i need to learn how to take out my 1995 Chrysler lebaron convertible motor
Is the convertible top motor hydraulic or electric?
It is both, an electric motor runs a hydraulic pump.
Where is the pump for your convertible lebaron top motor?
behing the rear seat
Where is the motor for the convertible on a 1992 Chrysler lebaron?
It is behind the rear seat.
How do you add hydraulic fluid to Porsche convertible top motor?
You can add hydraulic fluid to Porsche convertible top motor by popping open your engine hood and then pouring the hydraulic fluid into the appropriate compartment.
Where is convertible top motor located on a 1995 Chrysler LeBaron?
It is behind the rear seat.It is behind the rear seat.
Where is the 1995 Chrysler lebaron convertible top motor?
in the trunk.. upper right side...
Where is the wiper motor on a 1991 Chrysler Lebaron convertible 3.0?
The wiper motor should be located on the driver side under the cowl grill below the wiper blade good luck
What kind of fluid do you put in a 1992 lebaron convertible top motor?
Automatic transmission fluid.
Why does the top on 1989 LeBaron Convertible go down but not up?
possibly the up solonoid located in the trunk attached to the convertable top motor.
What type of hydraulic fluid is specified for a 1997 Chrysler Sebring convertible?
The convertible top motor uses automatic transmission fluid.The convertible top motor uses automatic transmission fluid.
How do you add fluid to a Chrysler LeBaron convertible hydraulic motor?
HYDRAULIC PUMP ASSEMBLY LeBaron Convertible Review the complete service procedure before starting this repair. The convertible top on this model will raise slowly or make abnormal noise if the hydraulic fluid level is low. Disconnect the negative battery cable. Remove the sling well and floor cover from behind the rear seat. Disconnect pump wire connector and ground connection. Disconnect hydraulic lines from the pump assembly. Remove the motor pump assembly from the vehicle. The rubber mounts are pressed and locked into the mounting bracket. Pull up motor assembly to remove. To install: Position the motor assembly in the vehicle. Connect the hydraulic lines to the pump assembly. Attach the pump wire connector and ground connection. Install the sling well and floor cover behind the rear seat. Connect the negative battery cable. Fill the pump reservoir with Dexron
