both left and right blinkers operate off of the same flasher. the flasher is a small module that plugs in usually under the dash just above your left leg as you are sitting behind the steering wheel. a bad turn signal bulb could also cause the dashboard indicator light not to blink.
The 2002 Monte Carlo blinker flasher relay switch is located beneath the drivers side dashboard. The blinker flasher relay switch will be above the brake pedal.
AnswerTo fix it do this : say the drivers side blinker goes on and does not flash. Well then you have either the front or rear blinker burned out. Thx KBThere's the possibility of burned bulbs, but if both sides fail to blink, replace the flasher unit.
Do you mean Flasher unit ? If so it is on the driver side kicker panel.
The fuse for the blinker of a 96 Cavalier should be in the fuse box inside of the car. A more likely cause would be the flasher, located under the drivers side of the dash.
There are 2 flasher relays. One for the turn signals located on the drivers side under the dash, drivers side of the steering column, mounted on a support bracket. There is also a hazard flasher relay located on the drivers side mounted above the kick panel.
look under the drivers side dashboard you will find the combination flasher unit, it is square and has a wire connector going into the side Try this site out, it might help you out. http://autorepair.about.com/library/pictures/illustrations/bl703lib.htm
On this model the flasher could be located in one of two places. It is either on the steering column just under the dash, or mounted on the fuse box under the dash on the drivers side.
the flasher is located in the steering coloumn. you have to remove the kick panels on the drivers side to get at it
The flasher relay switch is located beneath the dashboard, on the drivers side. The flasher handle is located on the left hand side of the steering column.
it is under the drivers side by the pedals, lie on your back under the steering column and it is the larger black relay on the right. You have to pull it hard to get it out and it should say Flasher and the part number good luck 2000 Toyota Sienna Blinker/Hazard flasher relay. Flasher relay part number toyota-81980-AA1, Flasher relay part number generic-Tridon EP35. Flasher relay location- Looking at the fuse panel from the feet up view, the flasher relay is on the back, left wall of the fuse panel. The relay prongs, quantity three, are enveloped by the flasher relay casing which makes it difficult to extract the flasher relay from its location. The flasher relay will need to be pulled up and away from the person removing it. After replacing the flasher relay; the flasher can be tested by actuating the hazard/emergency flashers button without the ignition key engaged, the left blinker or right blinker will not work without the ignition key engaged.
If you are asking for the location of the Turn Signal Flasher Relay, it is located in Junction Block 1A (under dash on drivers side). Block 1B has the fuses, Block 1A the relays. The flasher is the small relay at the end opposite the group of four (4) relays.
Drivers side, under dash, mounted on the drivers side of the fuse panel.