Im not quite sure as to what flasher you are speaking of but if its the emergency flashers those are on the dash next to the clock. If you mean high-beam flashers just flick the high beams instead of a full click and it flashes for you.
where do you install a new flasher for a 1991 Acura Legend?"
how to replace a water pump on a 1991 acura legend
Were are the timing marks on a 1991 acura legend
How do I put a alternotor belt on a 1991 Acura Legend
The map sensor for the 1991 Acura Legend is mounted on the firewall. It is in a box near the factory strut brace.
How do i pull codes for a 1989 acura legend
http://wiki.answers.com/Q/Where_are_the_fuses_for_the_1992_acura_legend_driver_and_rear_windows lokethed an the 1991 acura legend
On the steering wheel.
The 1991 Acura Legend starter is located on the right hand side of the engine, near the front, at the bottom. You can follow the positive battery cable from the battery to the starter.
its the dimmer relay
Bad switch? Bad hazard flasher?
Yes, any C32A engine from 1991-1995 will fit in any other model/trim within that year range, with no modifications.
3.2 l v6
under the back seat
On 1991 Legend models, the turn signal/hazard flasher is located under the steering wheel, in the interior fuse box (Furthest top right area with a cover over it) It's got five (yellow) twenty amp fuses on two sides.
The radiator drain plug is on the bottom edge of the 1991 Legend. It looks like a wing nut and is on the drivers side.
The camshaft position sensor on a 1991 Acura Legend is located at the back of the camshaft, near the rear bearing cap. It monitors the rotation of the camshaft and relays this information to the vehicle's computer.
Sure it is!.. I have a 1990 Acura Legend, and they are very reliable vehicles, I would just look into the Vehicles history, and the maintenance upkeep on the car..
you can use 10w30 or 10w40 either is fine
it's the blower motor
To replace the clutch disc in a 1991 Acura Legend you must first remove the engine from the vehicle. Loosen the pressure plate by adjusting the bolts and remove. Put the new one where the old one was and tighten the bolts.