It would be in the relay box under the hood near the battery.
Remove the glove box. The front blower motor and the resistor can be accessed from there.
Remove the glove box and the blower motor can accessed.
Bottom front of engine.
Front bottom of engine under the A/C compressor.
The horn is locared on the LH front of the vehicle, below left headlamp
Front of the transmission, the thing the shift cable attaches to.
On a Mercury Villager ( being a front wheel drive vehicle ) The transaxle ( transmission ) is located in the engine compartment to the drivers side of the engine
The oil pump is behind the front cover driven by the timing belt.
The distributor in a Mercury Villager is the round thing at the front of the engine with the six spark plug wires attached to it.
In the 1997 Mercury Villager, the Transmission fluid dipstick is located on the driver's side of the engine just in front of and below the master cylinder/brake fluid check. The 97 Villager has a bulbous knob on top with no indication that it is the Transmission fluid.
The Vehicle Speed Sensor on the 1996 Mercury Villager is located on the back of the transmission (as you look at the vehicle from the front) on top of the transmission with a pair of wires leading away from it... best to reach it from under the vehicle.
on the front passenger side of the vehicle it is the pump that has the third belt n it
The evaporator is in the A/C heater box under the dash.
That would be located under the car just in front of the second catalytic converter.
Front wheel drive
Your Villager has only one O2 sensor located on the front catalytic pipe before the converter. You should be able to look down between the engine and radiator and see it.
The starter is located directly underneath the brake fluid reservoir (which is located on the right front corner as you open the hood)...good luck
Bottom front of engine.
It is on the front of the engine on the end of the crankshaft.
In front of the engine, down in the "V".
At the front of the motor attached to the engine cradle.
The front wiper arms on a 1997 Mercury Villager clip off once they are bent backwards. To install the new wipers simply slide them into the clip.
The 1993 Mercury Villager takes 22" replacement windshield wiper blades on both sides front.
On the front of the engine in the center of the "V".