On air box right befor maf sensor
It is the top one
The sensor is located on th eexhaust manifold just above where the exhaust pipe joind the manifold. If its been on for a while, you'll probably need a torch to get it out.
The oxygen sensor on a b2500 Mazda is located in the exhaust. It is under the truck about even with the transmission.
There is two oxygen sensors. One is located before the catalytic converter is located under the heat sheld. The oxygen sensor after the catalytic converter is found under the catalytic converter (under the car) before the catalytic transfer pipe.
How to know if air sensor not working on protege 2003
remove the old one and install the new one. They are threaded in.
you can't fix a sensor, you can replace one by removing it and installing the new one...:)
where is the transmission shift solenoid located on a 2001 Mazda protege
Where is the EGR Valve on a 1996 Mazda Protege located at?
The Oxygen sensor is located on the manifold pipe.
Answerthe camshaft sensor is the distributor but the crankshaft position sensor is located right next to the crankshaft its held on by one bolt
Under the hood on the firewall passenger side it will say hitachi boost sensor on the top of it
At the top of the engine near the windshield on the passenger side.
no sensor only a thermostat
The cam sensor is located on the left side of the engine (as your looking at it) on the valve cover. It is the only sensor that is located on that side on the upper part of the engine.
need to know what wire go were for a 94 Mazda protege MAF sensor
Where is the flasher relay on the 1999 mazda protege
it is mounted to the strut tower between it and the firewall on the passenger side
i have a 1996 Mazda protege and it is at the rear of the transmission if you're looking from the front drivers side. it is almost directly under the throttle position sensor which is located on the rear of your throttle body close to the firewall (almost directly in the center of the engine compartment).
Yes, they are only good for either 60,000 or 100,000 mile depending on which type was used.
The 2000 Mazda ProtÃ©gÃ© map sensor is located next to the system computer. The map sensor and the system computer can be found behind the kick plate on the passenger side of the passenger compartment.
that is the cooling fan relay.
it is located on the motor in the front
The ECM on the 2000 Mazda Protege is located on the backside of the engine. It is half way up above the drive shaft.