there is a switch on the passenger side floor board under the dash. if you pull the carpet down it's close to the center hump,it's square with a reset button on the top.
Add your answer:
Related Questions
Where is Fuel pump cut off switch for a ford bronco?
the switch you are looking for i beleave is the inertia switch.. on your bronco i beleave it is located behind the glove box
Where is the inertia switch located on the 1989 Ford Bronco?
On the interior firewall to the left of the steering column
What's the weight of a 1986 ford bronco?
The Ford Bronco is categorized in one of five generations, with the 1986 model falling within the 3rd generation. The base curb weight of a 1986 Ford Bronco is approximately 4374 lbs.
Where is the fuel cut off switch located on a 1988 ford bronco?
under the dash,,drivers side
Where is the fuel intertia switch on a 1985 Ford Bronco?
its located on the passager side of the truck under the dash
O2 sensor on an 1986 ford bronco 5.0?
O2 sensors are located in the manifolds & front pipes
1986 ford bronco II?
what is the question?
Where is fuel shut off switch for 1988 Ford Bronco Eddy Bauer?
where is fuel shut off switch for Ford Bronco eddy Bauer
How much does a 1986 Ford Bronco weight?
The base curb weight of the 1986 Ford Bronco is 4,374 pounds. This is for the 4.9 liter North American version.
Does the 1986 Ford Bronco 2 take R134 AC refrigerant?
A 1986 Ford Bronco II would use R12 unless it has been converted
Where is the fuel pump relay and inertia switch on a 1986 ford bronco with a 302 engine?
on the fire wall driver side by the e brake
Where is the high and low beam switch located at on a 1984 ford bronco?
84 should be mounted on the drivers side floor
How do you change a key switch on a 1988 ford bronco?
to take the key switch out you need to press the little pin sized rod located on the bottom of the switch. once pushed in twist the switch out.
Will a 1993 ford ranger manual transmission fit in a 1986 ford bronco?
no.
Can a 1988 ford bronco motor go into a 1986 ford bronco?
yes you may have to inter change a few things but they will fit
Where is the Inertia Switch on a 1996 Ford Bronco?
On a 1996 Ford Bronco : I believe the fuel pump inertia switch ( shut off switch ) is located in the front passenger footwell , behind the kick panel * the kick panel is the interior trim panel , in front of the front door , beside the passengers right foot
Why 1986 ford bronco crank but no start?
Is there just a gear or a timing chain on a 1985 ford bronco 11 2.8 liter V 6.
Where is the set screw on the throttle cable located on a 1986 ford bronco II with a 2.9?
follow the cable to the throttle body and it is underneath the butterfly
What size gas tank does a 1986 ford bronco have?
33 gallons
Where can you find a soft top for a 1986 ford bronco?
http://broncograveyard.com/
Where is the fuel pump located on a 1992 ford bronco?
On a 1992 Ford Bronco : The electric fuel pump is INSIDE the fuel tank
How do you replace the turn signal switch located on a 1990 Ford Bronco?
You have to take apart the steering column, remove the steering wheel, remove the ignition switch, and it's a pain in the butt.
Wheris cut off switch on 1976 Ford bronco?
A 1976 Ford Bronco would still have a carburetor for the engine , so it does not have a fuel pump shut off switch ( inertia switch ) like the Ford fuel injected engines do ( that use an electric fuel pump ) * if that is what you mean
How much transmission oil does 1986 ford bronco takes?
about 13 quarts.
Where is the inertia trip switch on your 1996 bronco?
On a 1996 Ford Bronco : The fuel pump inertia switch ( shut off switch ) is located in the front passenger footwell by ( or behind ) the kick panel * the kick panel is the interior trim panel , in front of the front door , beside the passengers right foot
