I would look on the driver side firewall in engine compartment. Try tracing high pressure fuel hose from fuel rail. it is above the gas tank , you remove the back seat and change it from inside the car. bolloxs its in the engine bay clamped to the bulk head with two banjo type hoses on it one on the top and one on the bottom but its a sod to remove best left to a dealer. Rear seat will need to be removed. There is a panel in the floor, pop that open. Fuel filter is located below panel. The fuel filter is under the back seat in my 2000 Accent. Once you lift the backseat there is a small panel and if u lift that up it is in there. The filter has two connections on it one at the top and one at the bottom remove one slowly as some fuel may spray and then hold it upwards and have a rag handy to prewvent any fuel from getting on the interior when removing the other end. Just attach the new filter the same way the old one was. Dont stress if the car doesn't start immediately as fuel needs to go through the new filter.
Well in my 1997 accent it is located on the firewall in the engine if your engine is carburetor then it will be a plastic container
in the air intake box
It is located in the gas tank
The fuel filter on a 1996 Hyundai accent is located towards the rear of the motor. It is against the firewall. Just look toward the back of the engine and down and you will see it there.It looks like a small canister.
it is located directly under the engine it is in plain view if you look under it.
Type your answer here... Yes, is correct
The IAT sensor on a 1997 Hyundai Accent is found in the piping for the intake system. The sensor will be plugged and mounted near the air box for the air filter.
Remove rear seat, there is an access panel for the fuel filter. Remove access panel and have access to fuel filter.
in every car that I know its inside the glove box~take out the front part/open cartridge/replace and put front part back on
Look under the vehicle - follow fuel line from the fuel tank
It's under the back seat. Behind an access panel.
The filter is inside the transmission and is not to be serviced. Just drain fluid and replace.