passengerside under the back seat . Look on the outside of the body. Not in the passenger space compartment.
the PCM .is behind the battery under the hood.
Chrysler does not have reset switches.
Its in the fuel tank
its one of the 2 located on the right side strut tower in the engine bay
The only speed sensor on the engine is inside the distributor.
5 1/4 i know from experience 6 1/2 can be made to fit but not the easiest
the solenoid is ontop of the starter motor which is located at the bottom right of the engine.. 3 bolts hold it in...
1 4 3 2
It is on the lower portion of the passenger side of the firewall.
firewall passenger side lower
There could be a few reasons why a 1990 Chrysler Lebaron will crank but not start. The fuel pump could be out or the car could be out of gas. There may be a malfunction in the ignition system causing no spark.
By the fuel tank but I can't remember exactly where!
141 Horsepower @ 5000 RPM.
quick conts? get the tool from autozone.
It is an A604
last relay behind the battery.
no.. very different.. by hard top you mean 4 door..?.. the 4 door window mech is a scissors action.... the convert is on a frame and cabled..
The fuse box is located behind the lower dash panel on the drivers side.. also the relay board is located attached to the bulkhead to the left and upbehind the fuse box
Yes they could leak.
You add fluid down the same hole the dipstick is in.
You will find it (the PVC valve) in the same place as you would on a 1995 Lebaron 3.0. I own a 1990 Chrysler lebaron 3.0 v6 and found the PVC valve in the same spot. Look up where to find the PVC valve on a 1995 lebaron 3.0 on this site. Best of luck.