4.3 with filter.
The cruise control computer module is located on the passenger's side of the engine compartment on a 1993 Mercury Villager.
The cruise control module of a 1993 Mercury Villager is located under the passenger side of the dashboard.
Mercury Villager was created in 1993.
No, the 3.0 V6 in a 1993 Mercury Villager is NOT and interference engine.
fuses for seatbelts
There are ( 2 EXHAUST MANIFOLDS ) on your 1993 Mercury Villager 3.0 liter V6 engine
the elictronic control sinsor at on a 93 mercury villager
It is located in the gas tank. The tank must be removed.
The VSS is located on the bottom of the transaxle beside the exhaust manifold.
Yes, exactly the same.
On the starter.
You need to tee in at the fuel filter connection, there is no schrader valve.
Yes, the 1993 Mercury Villager was a 1992 Nissan Quest. The last year Nissan used a Carburetor on a Quest. Fuel injection system replaced the carburetor in 1993.
According to one of Ford's websites : The spark plug gap for a 1993 Mercury Villager , 3.0 V6 is : ( .032 inch )
The 1993 Mercury Villager takes 22" replacement windshield wiper blades on both sides front.
The IAT is located in the air intake tube before the MAF.
The MAP sensor should be on the firewall just above the brake booster.
the unit is under the steering column.actually its stuck on the steering column and its a black plug
Near the firewall behind the engine, or under the dash near the heater core.
The oil drain plug is located on the lower right side of the oil pan. You can easily get to the oil drain plug and oil filter by removing the right front wheel.
According to fordparts.com the spark plug gap is ( .032 inch ) on a 1993 Mercury Villager with the 3.0 liter V6
Timing is set by the PCM and is not adjustable.