Fuel Filters

Where is the fuel filter on a 90 Sunbird with 2.0 liter OHC and throttle body injection?

106107108

Top Answer
User Avatar
Wiki User
2004-04-22 15:45:30
2004-04-22 15:45:30

Should be behind the gas tank. Make sure you relieve the fuel pressure before you disconnect it. You can relieve the fuel pressure by removing the fuse for the fuel pump (f/p)and turning the car over.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The 1997 Ford F150 4.6 liter engine throttle position sensor is located on the top of the transmission. The sensor will be connected to the fuel injection rail.

User Avatar

yes, yes it does no, its the crappy tbi systems. tbi stands for THROTTLE BODY INJECTION! it has fuel injectors and has to be treated as such. it is not carbureted.

User Avatar

the tube from air filter box hooks inti it at engine

User Avatar

yes a 1993 4.3 liter motor can have (cpi) centralport injection) (spyder injection) if your blazer has a (w) has it 8th vin letter then yes it does but if it has a (z) from a 8th letter on your vin number iz a (tbi) throttle body injection

User Avatar

There is not a carb on a fuel injected vehicle. It has a throttle body. the amount of air to fuel ratio is controlled by the computer.

User Avatar

the filter is located under neath at back wheel on the drivers side the lines and filter is obvious just un clamp and change it.

User Avatar

On the 4.0 liter V6 the big rubber engine air intake tube goes from the engine air filter to the throttle body located at the front / top of the engine

User Avatar

CHEVY guit using carburetors back in 1987. You truck is fuel injected / TBI. Throttle body injection.

User Avatar

It is located in the air intake tube from the air filter to the throttle plate.

User Avatar

Yes. The only difference is the TBfI and MPFI. (Throttle body fuel injection and Multi port fuel injection and corresponding computer controller.

User Avatar

Three wire sensor on the throttle body.

User Avatar

Its usually in the rubber tube coming from the air filter box to the throttle body. At least it is on the 3.1 and 3.3

User Avatar

The throttle positioning sensor is located in the throttle body.

User Avatar

in lower intake Manifold at the back, also replace breather filter under the PCV.

User Avatar

Front of the throttle body.Front of the throttle body.

User Avatar

No, the throttle body and multi port heads are not interchangeable.No, the throttle body and multi port heads are not interchangeable.

User Avatar

The throttle body is controlled by the engine computer, which is located on the firewall.

User Avatar

There are several frost plugs on a 1994 Sunbird LE 2.0 Liter. They are located on the sides of the motor toward the back. Look for a round disk that is depressed in the center. There are two frost plugs on each side of the motor.

User Avatar

Copy and past this link. http://www.autozone.com/az/cds/en_us/0900823d/80/0e/d5/ca/0900823d800ed5ca/repairInfoPages.htm It will take you to Autozone.

User Avatar

No it would not, need to check fuel pressure with a gauge first Then I would clean the throttle plate real good with cleaner and tooth brush or rag. This is where the duct work comes from the air filter to the engine, take it loose and you will see the throttle plate.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.