Dashboard Lights and Gauges
Fuel Filters
Fuel Pumps
Chevy Suburban

Where is the fuel gauge for 1990 Chevy Suburban located?

161718

Top Answer
User Avatar
Wiki User
2009-07-23 21:53:16
2009-07-23 21:53:16

If you do not know the answer to this, then you should not be driving a vehicle. You should not even have a license. Take your license and throw it away. Or you can just wait until you run out of gas to know that you are empty. Make sure you carry an extra few gallons of gas wherever you go (Unless you don't know where the gas cap is).

in the dash. the one that has an f at the top, and an e at the bottom.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

1990 Chevrolet Lumina temperature sender is located on the back side of the thermostat housing. The sender has a wire that goes to the temperature gauge.

User Avatar

There is no reset switch for GM fuel pumps. What is the problem you are trying to solve? Stan

User Avatar

Connect a fuel pressure gauge to the schrader valve located on the fuel rail that feeds the fuel injectors.

User Avatar

YES, They are the same engines. That would be a direct bolt in.

User Avatar

It is on driver side of Transmission behind the shift linkage

User Avatar

Fuse for headlights 1990 Chevrolet suburban is located on the driver's side dash on left right behind the fuse panel. It is just above the parking brake.

User Avatar

Where is the Water Pump located and how do you replace it on a 1990 Chevy Corsica?

User Avatar

It is most likely the oil pressure sensor, located on the front of the engine block near the oil filter. There is also a slim possibility that the gauge in the instrument cluster is defective.

User Avatar

yes 90 trough 99 are the same base models

User Avatar

The most common problem that causes that is Bad valve seals in the head.

User Avatar

About 15 mpg on a 1990 Chevrolet suburban.

User Avatar

On my Chevy lumina it is located right by the gas take on the right side of the car.

User Avatar

If you are replacing make sure that you bench bleed prior to installation

User Avatar

It is inside of the fuel tank. You will need to remove the gas tank to service it.

User Avatar

It is an Inline fuel filter located along the left side frame rail, on the inside of the frame. Just follow your fuel lines from your fuel tank and its not that hard to miss, its about halfway up the frame

User Avatar

where are the temperature sending unit located on a 1990 Chevy engine 5.7

User Avatar

1990 Chevrolet suburban gets about 15 mpg.

User Avatar

There are four motor mounts located on a 1990 Chevy Lumina. Two on either side of the engine. One the rear and one in front of the engine.

User Avatar

The coolant fan switch is located close to the thermostat.

User Avatar

It is a the tail end of the transmission and should have a 2 prong connector.

User Avatar

Not to my knowledge there is not. I have a 90' suburban with the barn doors. The hinge mounts are a part of the actual body. I do not believe the mounts are manufactured into the body of a suburban with a tailgate.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.