0
Where is the fuel pressure regulator on a 1998 Chevy S10 Blazer 4.3?
Wiki User
∙ 15y ago
it is located on the fuel rail .
Katheryn Barrows
Wiki User
∙ 12y agoLeft side of the engine as you are facing it, at the rear closest to the firewall. It connects to the Fuel rail and is held in place underneath with a button screw which is hard to reach. It will have a vacuum hose that will attach to the top front of the throttle body. Check the plastic line before replacing the regulator. Most the time the vacuum line will break before the regulator gives up.
Wiki User
∙ 15y agoThe 1998 Chevy S 10 Blazer 4.3 liter engine fuel pressure regulator will be on top of the engine. The fuel pressure regulator will be attached to the injector fuel pump.
Wiki User
∙ 14y agoPeople will need to know if it's a throttle body injection (TBI) or a vortec injection to answer you.
Wiki User
∙ 15y agoIt is in the fuel line on the driverside of the intake plenuem, The fuel line is black.
The regulator is round and has a rubber hose hooked to it. It is held in by a medal clip.
Wiki User
∙ 14y agoUnder the upper intake manifold. It is attached to the bank of fuel injector poppets.
Wiki User
∙ 10y agoIt is on the pump module in the fuel tank.
Wiki User
∙ 14y agoIt is in the throttle body.
Add your answer:
Earn +20 pts
How many water pump weep holes are there on a 1998 Chevy Blazer with a 4.3 liter engine?
Two, one on top and other on bottom
Why won't my 1998 Chevy blazer start. Cranks but won't start Have to add fuel into air cleaner?
Replace the coolant temp sensor.
Where is the voltage regulator on a 1998 Lincoln continental?
it should have the voltage regulator built into the alternator
What vacuum related part needs to be replaced on a 1998 Chevy Blazer makes you reset from 2 wheel drive to 4 wheel then back again to 2 wheel drive?
I am trying to figure this out myself. I have a 96 Chevy S-10 Blazer and I believe it is the vacuum acuator located under the battery box in the engine compartment.
Can i have a diagram of where the relay switch on your 1998 Chevy blazer?
Most of the relays are located in the power distribution box under the hood. It should hold the horn relay, AC relay, fuel pump relay and others.
Where is a pressure control solenoid located in a 1998 Chevy blazer?
Not sure what pressure control solenoid is, could it be the fuel pressure regulator?
Where is the fuel pressure regulator located on a 1998 Chevy van?
Where is the fuel pressure regulator located on a 1998 Chevy van
Where is the oil pressure switch located on a 1998 Chevy Blazer?
The oil pressure switch on a 1998 Chevy Blazer is on the side of the engine block. It is located above the oil filter.
Where is the fuel pressure regulator on a 1998 Chevy blazer with throttle body?
The 98 Blazer with a 4.3L V6 fuel pressure regulator would be located under the upper intake manifold. It would be attached to the bank of fuel injector poppets aka "the spider". The upper intake manifold would have to be removed to gain access.
How do you get a pulley off a 1998 Chevy Blazer?
HOW TO GET A PULLEY OFF A 1998 CHEVY BLAZER
1998 Chevy s10 blazer fuse block diagram?
I need diagram for 1998 chevy blazer fuse panel
Will a 2000 Chevy s10 blazer 4x4 transmission work for a 1998 Chevy s10 blazer?
Will a 2000 blazer transmission fit a 1998 s 10 chevy 4x4 truck
Where is the fuel pressure regulator on a 1998 Chevy pickup 4.3L Vortec engine?
Under the upper intake assembly
Will a 1998 Chevy Blazer motor bolt up to a 1996 Chevy Blazer?
YES they are the same.
Why wont my 1998 Chevy Express 1500 van w350 start but will crank over?
try the fuel pressure regulator
Where is fuel gauge fuse on 1998 Chevy blazer?
The fuel gauge fuse on 1998 Chevy blazer is located in the front of the blazer. It is on the driver side next to the hook latch.
Will a 1995 Chevy blazer 4.3 L fit into a 1998 Chevy blazer 4.3 L?
Yes.
