General Motors products do not use inertia/reset switches
Chevrolet does not use an inertia switch on any of their vehicles. If your fuel pump doesn't run something is broken
it does not have an inertia switch.
Chevrolet does not use cut off or inertia switches.
GM vehicles do not have an inertia fuel cut off switch.
No
I can tell you for a fact it is not an 4L80E, the "E" stands for electronic and there are no wire connectors on an 1989. Installing a 4L80E in an 1989 would require changing a lot of wiring harnesses and the computer for your truck. Good luck.
where location of brake light switch on 1989 chev, truck.
Check the manifold, just before the headpipe.
Yes. Look in the yellow pages for aftermarket a/c's
The 1989 Chevy Silverado pickup truck window wiper relay switch can be found on the firewall in the engine compartment. The relay switch will be on the passenger side of the firewall.
Neither the front or rear bumper of a 1989 Chevrolet truck will fit on a 1989 Dodge truck. The bolt patterns are different and will not line up.
I had a similar problem on a Ford truck and it turned out to be the ignition switch. The truck would start just fine but when I released the ignition key the truck would die. I replaced the switch and problem was gone.