Fuel Pumps
Oldsmobile Cutlass Supreme
Ford Expedition Eddie Bauer

Where is the fuel pump relay located on a 1990 V6 Cutlass Supreme?

161718

Top Answer
User Avatar
Wiki User
2006-11-16 02:52:47
2006-11-16 02:52:47

located under hood, on drivers side, near wheel well. just replaced fuse in mine.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

I've got an 89 cutlass ciera and it is located behind glove box. open and pull out like 4 screws and there it is.

User Avatar

I have a 1990 Cutlass Calais. I had to remove a plastic panel under the steering Column. It was located to the left of the column under the dash.

User Avatar

The master cylinder contains the reservoir for the brake fluid. This is where you would add it on an 1990 Cutlass Supreme.

User Avatar

I have 90 cutlass supreme. look under center of car for gas tank. should be on back end of the tank. need to jack up high enough to get at.

User Avatar

the alternator is located on the upper left hand side of the engine. just follow the belt and you will find it located at the top.that is where mine is.

User Avatar

According to http://consumerguideauto.howstuffworks.com/1990-to-1997-oldsmobile-cutlass-supreme-4.htm, the fuel capacity for the 1994 Cutlass Supreme is 16.5 gallons. Many years ago I owned a 1968 Cutlass Supreme convertible--a very fun car.

User Avatar

Its in the engine compartment of the vehicle on the right hand side of the vehicle (your left) by the charcoal canister.

User Avatar

The firing order for a 1990 Olds cutlass supreme 3.1litre is 1, 2, 3, 4, 5, 6. The number one cylinder is closest to the pulleys on the left as you face it.

User Avatar

The EFI relay is located under the dash on a 1990 Honda. It is on the driver's side, under the steering column.

User Avatar

you probably have half American standard and half metric.

User Avatar

the fan blower relay is located in the front left hand side looking at the car. right behind the headlight. there are 4 relays there. it is the one on the far right. I just replaced it.

User Avatar

were is the relay 1990 corvetter cooling fan located at

User Avatar

Use a "C" Clamp to fully retract the piston into the caliper body

User Avatar

you will have to drop your gas tank its inside the tank drive safe

User Avatar

GM vehicles do not use inertia/reset switches.

User Avatar

I found it in my repair manual. It is about 26 to 32 psi.

User Avatar

You can find several relay switches on your 1990 Cadillac Sedan Deville. Most relay switches will be in the fuse box. The relay switches will be in the third column of the fuse box.

User Avatar

Pull the turn signal lever towards you until it clicks, then let it go.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.