answersLogoWhite

0


Best Answer

In the trunk to the far left side under the floor board.

User Avatar

Wiki User

โˆ™ 2007-01-28 21:49:54
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the fuel shutoff switch in a 4cylinder 91 ford probe or does it have something else?
Write your answer...
Submit
Related questions

Where is the fuel shutoff switch located on a 1990 Ford Probe?

it is on the bottom left side of the trunk must take entire panal to see it


Where is fuel shutoff switch in 1995 ford Probe?

If it's the same as the 1996 Ford Probe , it's in the hatch area - lift the carpet in the drivers rear area of the cargo area , you will see a rubber cap / plug , push the raised area of the plug in order to reset the fuel shut off switch


Can you put a Mazda transmission in a 1994 Probe?

Yes. Be sure to change the neutral switch from your probe as the mazda's will plug in but is wired different.


How do you change oil pressure switch on ford probe gt?

o my


My 93 probe has the fuel cut out switch on and refuses to start. how do I fix it?

are you sure its fuel cut out? my probe would not start traced problem to electronics inside distributor had failed [common fault on probe]


How do you find the fuel cut iff switch on a 1997 ford probe car?

find fuel cut off switch


How can you by pass an inertia switch on 1993 Ford Probe?

If you crimp the three wires running to the inertia switch together and remove the switch, it will close the circuit thus bypassing the swich. I have a 1993 Ford Probe SE that this has been done to and as of yet it has no direct or indirect complications from doing this. If you crimp the three wires running to the inertia switch together and remove the switch, it will close the circuit thus bypassing the swich. I have a 1993 Ford Probe SE that this has been done to and as of yet it has no direct or indirect complications from doing this.


Where is the fuel pump reset switch located on a ford probe 1989?

Trunk


What is a probe?

A probe is a tool that is inserted into something to view or get information abour what is going on inside that object. A satellite that goes into deep space is an example of a probe.


How do you reset the fuel pump shutoff on a 1994 ford probe?

In the trunk under the carpet on the left hand side there is the cut off switch.It is bacicly above the left rear tire


Where is the inertia switch on a 94 Ford Probe?

in the trunk. under the carpet, in the leftside quarterpanel


Where is the Oil Pressure Switch on a 92 Ford Probe?

The oil pressure switch should be above the oil filter on the back of the engine on a 2.2L.


How do you find the cutoff switch on a 1994 Ford Probe GT?

the Inertia Fuel Shutoff Switch is located in the trunk. It is mounted under the luggage compartment floor cover at the back of the LH rear cargo storage compartment. The reset button must be pushed to reeet the IFS once it has been triggered. Basically it is behind the rear wheel well under the trunk mat close to the rear quarter panel. Good luck. Gus


Where is the inertia switch on 1993 Ford Probe?

hi, i could'nt find the inertia switch on my ford probe 1994 for ages. Eventually I found it just above the wheel arch on passenger side in boot but you have to remove the plastic covering. Not easy to locate. Hope this helps.


What is the use of Probe laboratory tool?

tool that you use to dissect something with


Why does Ford Probe ignition stays on even when key is not in ignition?

Defective ignition switch or tumbler assembly.


How do you find the cut off switch on a 1997 ford probe?

If you are talking about a fuel cutoff switch then it is in the trunk right next to the fuel hose there is a little red button


How do you pile photon cannons on top of each other in Starcraft?

Hot key a probe (control, 1) then if there is a light switch turn the lights off. There has to be a light switch for stacking. After the lights are off press 1. This will select your probe. Then you can make cannons and other buildings on top of each other.


Why would a 91 Ford Probe shut off while running and only start when fuel is poured directly into the engine?

Fuel pump/fuel filter need replacing. 1991 Ford Probe has fuel cut off switch located in trunk, if car ran over bump, hit something in road, that bounced up under car, possibly caused switch to shut off. pouring gas into engine will only work as long as you pour gas.Try resetting cut off switch to start fuel pump.


Where is the fuel pump reset switch located on a '93' Ford Probe?

If you are talking about the inertia switch, it is in the hatch on the driver's side under the floor mat behind the wheel well.


Where is the low coolant switch located on 2002 Buick Century?

The switch is just across from the battery located in the rad reservor, to remove it and clean the sensor probe, you have to remove the battery.


How to reset a fuel switch located in the trunk of a 1992 ford probe?

in this case its ok to push the red button


Where is the netral safety switch located on a 1997 probe?

Under the air cleaner box, on the right side of the transaxle.


Can you use a fog light switch from a prob gt for aftermarket fog lights on a probe base model?

Yes you can.


Where does a probe go?

I think it mean to go up your bottom or something like that.

Study guides

๐Ÿ““
Create a Study Guide