answersLogoWhite

0


Best Answer

in my 98 sebring,there is also a fuse box located under the hood not far from the battery.in that fuse box there is a yellow fuse holder in the upper right hand corner. remove fuse holder.it should have 2 fuses in it.fuses slid out the side of yellow fuse holder.they are removed and inserted as a pair.hope that helps

User Avatar

Wiki User

โˆ™ 2009-11-11 03:18:52
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the fuse for the alarm located in a 1997 Chrysler sebring?
Write your answer...
Submit
Related questions

Is there a fuel reset on a 1997 Chrysler Sebring JXI If so where is it located?

A Chrysler Sebring does not have a reset switch.


How do you disconnect the car alarm in an 1997 Chrysler Sebring?

The factory alarm is built into the body and engine computers and can not be removed.


Where is crank sensor located on 97 sebring lxi?

where is the crank sensor located on my 1997 Chrysler sebring lxi


Where is the hydraulic pump for the 1997 Chrysler Sebring convertible located?

The Hydraulic pump for 1997 to 2006 Chrysler Sebring convertible is located behind the back seat and center of the car on a small shelf.


How do you disable the alarm on a 1997 Chrysler Sebring?

The factory alarm can not be disabled. It can only be reset by unlocking the doors with the key or use the remote.


Will a 2001 Chrysler Sebring fender fit on a 1997 Chrysler Sebring?

No,No,


What are the symptoms of a bad thermostat on a 1997 Chrysler Sebring Lxi?

what are the symptoms of a bad thermostat on a 1997 Chrysler Sebring Lxi what are the symptoms of a bad thermostat on a 1997 Chrysler Sebring Lxi


Where is the cabin filter on a 1997 Chrysler Sebring?

A 1997 Sebring does not have a cabin filter.


Where is the fuel filter located on a 1997 Chrysler Sebring Convertible?

Above the gas tank


Where is the Cmp located on a 1997 Chrysler Sebring 2.5?

It is an internal, non replaceable, part of the distributor.


Where does the 1997 Chrysler sebring knock sensor located?

The Chrysler Sebring knock sensor is located in the engine valve or cylinder located at the back of the motor. This part is in this position next to the engine valve so the sensor can feel the vibration of the engine.


Is there a battery in the key of a 1997 Chrysler Sebring?

No.No.


What is the type of transmission is in a 1997 Chrysler Sebring?

Chrysler 41 TE


Where is the fuel shut off switch of a 1997 Chrysler Sebring JX Convertable and how do you reset it?

A Chrysler Sebring does not have a reset switch.


Where is the dipstick on a Chrysler Sebring?

For a 1997 Sebring Convertible the oil dipstick is located just left of center towards the front of the car and should be labeled "engine".


Where is the reset button on a Chrysler sebring 1997?

No reset buttons on Chrysler products.


What oil is used in a 1997 Chrysler sebring?

5W20


Where is the alarm unit for a 1997 Chrysler Sebring?

The factory alarm is controlled by the engine and body computers. The engine computer is under the hood and the body computer is under the dash on the back side of the fuse panel.


Where is the reset button on a 1997 Chrysler sebring?

Chrysler does not use reset or inertia switches.


Where is the oxygen sensor bank 1 sensor 2 located on a 1997 Chrysler Sebring lxi?

It is behind the engine, after the catalyst.


Is the fuel pump on a 1997 chrysler sebring electric?

Yes.


How do you get codes on a 1997 Chrysler Sebring?

You have to use a scan tool.


Does a 1997 Chrysler sebring have a timing chain?

No, it has a timing belt.


Where is the thermostat on a 1997 Chrysler Sebring convertible 2.5L?

On a Chrysler Sebring 2.5L the thermostat is under the housing where the lower radiator hose hooks to the engine.


Where can you find a stereo wiring diagram for a 1997 Chrysler sebring convertible jx?

A stereo wiring diagram for a 1997 Chrysler Sebring can be found in its maintenance manual. It can also be found in its repair manual.