there is a brake light fuse in the pannel you just need to look for it.
check the fuse for the brake lights, they have thier own. also check the brake light switch at the at the top of the brake petal
replace fuse and hazard flasher
there will be three things to check, first your fuses, they are located under the dash on the drivers side, and there is a fuse box under the hood. the 15 amp fuse under the hood in plug 27 is the fuse for the brake lights. if the fuse checks good will need to check the brake light switch on the brake pedal.
It should say TAIL for taillights or maybe brake lights.
the fuse panel on my 98 is on the left end of the dash. open the door to see it. my brake lights stopped working but did not blow the fuse. had to change the brake switch located on the brake pedal. good luck
Where is the fuse locations? Interior and brake lights have gone out while attempting to replace fog lights.
The cruise control is fed by the engine computer through the brake light switch. It does not have a separate fuse.If the engine runs and the brake lights work, it is not a fuse.
The fuse for the brake lights is in the engine compartment fuse box, located behind the battery. Open the lid. Several fuses are marked but many are not. There is a group of 12 fuse sockets in the middle of the panel, arranged in 3 rows and 4 columns. The brake light fuse is in row 2, column 2. It powers left, right and middle brake lamps. If your brake switch fails in the ON position, you can pull this fuse until you can get a replacement switch. The drain of these lights being on can kill your battery overnight. Do not drive car without brake lights!Answerthe fuse panel is located behind the kick panel on the pass side, just below the dash.(to the right of where your feet sit in the floor board) there is also another power distribution panel under the hood next to the battery. Answerthere is no fuse marked brake lights on jeep cherokee's if you have no brake lights and all bulbs are good your problem is the brake switch mounted on your brake pedal, about 30 bucks.
The brake lights may not work on a 1993 Honda Prelude if the brake light switch is no longer working. The brake light switch is in the steering column just above where the brake pedal is bolted to it. There is also a chance that a brake light fuse is blown.
Check the fuse, and the bulbs, then the switch on the top of the brake pedal
There should be a fuse for the brake lights. If the fuse is good always check the ground wire.
my fuse panel (with the descriptions) is gone off of my 2000 jeep grand Cherokee Laredo, how to i get a description of what all 32 fuses control on my jeep?
Fuse 7 controls the brake lights. It should be a red 10amp fuse.
what number fuse is for the brake lights on a 99 vw passat what number fuse is for the brake lights on a 99 vw passat
The brake lights are a separate circuit from the tail lights. If the bulbs and fuse checks okay, I would suspect the brake light switch is at fault.
Yes there is a fuse for your brake lights. Check your fuse box. It should be marked. If the fuse is ok then check the switch. It could be a bad switch or ground.
should be the tail lights fuse
this sounds like a fuse or 2. that's where i would start.
What fuse controls the brake lights on a 1998 Chevy Camaro? It should be labeled on the fuse block.
What fuse is for the 2005 Ford mustang Rear Brake lights?
Brake light fuse
Bulbs , Flasher under dash, broken wiring
Check fuse number 4 on the inside fuse panel, something made it blow though so expect it to go again until you find the reason.
It is not necessarily the fuse. It could be the switch on the brake that is not closing the circuit.