Ford Crown Victoria

Where is the fuse located for the spot light on your 2003 crown Victoria police car?

123

Top Answer
User Avatar
Wiki User
Answered
2013-02-22 05:29:24
2013-02-22 05:29:24

On a 2003 Ford Crown Victoria :

( fuse # 20 is a 20 amp fuse for the spot light )

In the fuse panel under the drivers side of the dash

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


In a 2007 Ford Crown Victoria : In the Power Distribution Box ( which is " live " ) located in the engine compartment near the battery ( mini fuse # 2 is a 20 amp fuse for the spot lights on police vehicles )

on my 98 crown vic you have to push in the head light switch

If it's the same as the 1999 Ford Crown Victoria " civilian " version : The O/D OFF ( Overdrive Off ) light is above and just to the right of the speedometer

What's wrong with it? No light, no electricity to the bulb socket, loose in ceiling...? Radioman

The brake light that is in the rear window of the Crown Victoria is accessible from inside the car. A small screw will loosen the housing, enabling access to the light.

It's on the Gauge Cluster, Green Light With OD in the middle.

Switch should be located at the upper end of parking brake pedal under dash area Light is common with low brake fluid light

If it is around '96, the switch is on the dash panel, left side of the steering wheel. Should have a timer on it also.

Normally this is an indication of a defective brake light switch.

A wrench light on any car means the engine needs attention.

It's on the arm of the brake pedal.

if its an old Police car it may have "Dark Car Mode" activated depending on the year you may need to have the LCM reprogrammed.

Remove the wiring harness from the back of your 1997 Ford Crown Victoria hazard lights switch. Remove the hazard light switch retaining screws. Reverse the process to install your new hazard light switch.

There should be a SWITCH at the dome light! If not, remove the fuse from the fuse box above where your gas pedal is. OR: Simply remove the BULB from the dome light. duncanw.

Your Car has a LCM (Light Control Module) and it sound like the relays are going bad. You will need a new LCM or have it rebuilt.

A flashing air bag light on the 1992 Ford Crown Victoria means that the airbag system has been disabled. This could be because it is damaged or because the key for the system is turned to "off."

3. 2 for the main lites, and 1 in the center

Check the bulbs, the fuse then the brake light switch.

take off the ground from the battery then put it back

My husband just bought a fuse for our car Crown Victoria 2000 Police Imtercepter since clock and auto park light were not work. the part number is F2UZ14526N for circuit. one problem that we lost guide manuel book. ai need to know where it will be locate it is somewhere under steering as fuse box as we are not sure. Either #6 or #11 in the fuse panel


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.