If you replaced the flasher on your 1999 Mercury Cougar and your turn signals are still not working, you should check the turn signal fuse. This fuse is located under the dashboard on the driver's side of the vehicle to the left of the steering column.
in the steering colume there is a little box connected to turn signal you replace that little box but you have to take lower colume off.
it is located on top of your steering wheel column
The emergency flashers for the 1997 Mercury Cougar are on top of the steering column behind the wheel.
My 2000 E320 fuse box for the turn signals is located in the panel to the left of the sterring wheel. You need to open the driver's door to see the panel. There is a card inside that provides the fuse location. We replaced the fuse for the turn signal position, however our turn signals still don't work- any ideas?
The 2003 Mitsubishi turn signal fuse can be found in the fuse box. The turn signal fuse will be in the second column, fourth from the top.
under the hood you should find a small 10A or 15A fuse. There is a separate fuse for the trailer turn signals.
if only one turn signal is out your looking at a blown bulb not a fuse as the turn signals are on one fuse if it blew none of your signals would work but to check anyway look in manual to find which fuse is turn signal fuse located fuse box and pull it
Fuse box is in glove compartment left side, Fuse box is marked,the one for turn signals is marked "TAIL"
the fuse is under the fuse cover left under the driverside-left air vent. inside the cover is the schematic for fuse locations and what they are. the fuse for the turn signals is the fifth from the bottom on the left side of the two rows of fuses. it is a 10amp fuse.
it is a small rectangular-shaped switch unit located in a clip on a bracket to the right of the steering coulumn
The flasher for turn signals in located on the fuse block. The fuse block is on the bottom of the dash to the right of the steering column.
look in fuse box circular fuse that controls all signals located under dash on drivers side kick panel.
In the fuse box. They are often labeled.
because of a flasher switch, located in the fuse panel.
The fuse that controls the turn signals on a 1994 jeep Cherokee is fuse number 16. This is a yellow 20 amp fuse.
my turn signals do not work in my 1992 Pontiac Firebird
First thing to check for is a blown fuse. Look in your owner's manual for location of fuse - if you don't have a manual, look in the fuse block.
Check the turn signal relay. The four way flasher and the turn signals each have their own relay. It has a fuse for the turn signal
#22 - 10 amp fuse - Turn Signals ( in the fuse panel on the drivers end of the dash - the plastic removable fuse panel cover is visible with the drivers door open )
fuses for signals on lincolns are located under panel to left of steering wheel book will give specific location number of fuse it is a 15 amp fuse
I asked my dealer the same question and he said there is no fuse for the turn signals. There is a flasher assembley. If you think you blew a fuse check the flasher assembley but where is that?
Flasher and fuse
It is located under the dash, against the firewall, all ther way to the left.
you have to remove the sound dampeners on the bottom of the steering column and it will be to the right of the fuse block