Grand Am SE

Where is the heater core located in a 1993 Pontiac Grand Am SE?

151617

Top Answer
User Avatar
Wiki User
Answered
2007-10-05 22:47:23
2007-10-05 22:47:23

Behind the dashboard just off center.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


It's tough for an amateur. The heater core is inside behind the console.


how do i replace a water hose in 1993 pontiac grand am


The camshaft sensor on a 1993 Pontiac Grand Am is located behind the rear bearing cap. It detects the position of the camshaft as it rotates and relays this information to the computer.


A 1993 Pontiac Grand Am weighs approximately 2,828 lbs. The Pontiac Grand Am stopped production in the year 2005. The car was replaced with the Pontiac G6.


If it is not visible at the door jamb, it is probably located in the latch mechanism


yes it will pontiacs are interchangable from the years 1993-1996



front of the motor bottom of the block on my 96


collant will start coming out of the hole where the a.c. condensation water comes out against the firewall


Should be against the firewall towards the passenger side


Under the dash in front of the drivers' left knee.


The blower rheostat on a 93 Pontiac Grand Am is located inside the engine bay, just to the right of the blower fan housing. It is almost directly behind the trans dipstick. It isn't that hard to replace.


the heater core will need to be replaced with a new one. go buy a book and plan on spending a complete saterday on it.


If your 1993 Pontiac Grand Am will not shift into part, the transmission is probably seized up. The first step is ensuring the transmission fluid is not too low.


The remote trunk release for a 1993 Grand Prix is in the gove box.


MOST horns are located behind the grill on one or both sides. A Few are on the inside of the fender.


It should be located just to the right of the steering column under the dash. between the radio and column..


It is under the hood in the main power distribution box. The schematic is on the underside of the cover.


Do you live in an area that you need your heater?


behind the glove compartment inside the heater assy


IF ITS A QUAD 4 THE HOUSING IS ON THE RIGHT SIDE OF THE VALVE COVER BY THE POWER STEERING BELT 2 BOLTS.


In the 1993 Pontiac Transport Van, the two heater cores are interchangeable. To install one heater core in another position, longer hoses might be necessary to reach the necessary hose positions and new holes might need to be drilled.



Usually against the passenger firewall




Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.