answersLogoWhite
Ask
Chevy Silverado
Heater Cores and Blower Fans
Ford Explorer Eddie Bauer
Ford Explorer XLT

Where is the heater resistor and how do you replace the blower motor on a 93 Chevy truck?

939495
Answer

Top Answer
User Avatar
Wiki User
2011-09-13 10:51:23
2011-09-13 10:51:23

To get access to the heater resistor you will have to take the passenger side glovebox liner out by unscrewing the screws holding it in place.You should see where 2 or 3 wiring connectors are secured.Look above and behind these connectors and you will wiring connector that appears to plug directly into the air circulation housing,but actually that is the resistor screwed into the housing.Disconnect the wiring connector and the2 screws holding it into place and it will pull right out.There is not a lot of room to work back there so you may have a little trouble getting to that right side screw.Good luck

how do you change a blower motor on a 99 Chevy k2500

12
0

Related Questions

User Avatar

If you are referring to the blower motor resistor, it is located behind the glove box and in the heater case.

User Avatar

resistor usually located by blower motor.blower only works on low or high,then replace resistor .do not replace hvac unit in dash waste of time and money

User Avatar

take it to a shop and have them do it If it's the same as a pickup, take out the glove box and the resistor should be on top of the heater box. Not much too it.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.