with a hammer
hi just bought a mazda 323f but need to remove damaged bumper how do i do it please
Mounted on top and inside the fuel tank.
try rockauto.com or your local junkyard
Timing belt - usually replaced with service every 54,000 miles. The belt is available on its own, or as part of a kit, including the idler pulleys.
I have just bought a 2003 323f 1.6 petrol, I have been informed that a change should be done every 54k or 10 years!
according to a website, The Mazda 323F 1998 1.5 GLX weighs a stated 1085 kg at the kerb. Sincerely. Saeid Hatam
The website www.manualsunlimited.com has a wide selection of manuals for vehicles- both foreign and domestic, covering a wide range of years. Many are available on CD-ROM.
Check break liquid level. I did it, and its works! Cicipapa
My 94 Mazda v6 323f feels like its going to die if i press the accelerator fast, but if i build up the revs slowly, it is smooth. The idle is smooth too. Is this an O2 sensor problem or another? How do I test if the sensor is faulty or not?
The best i have found is an owners manual. http://jdmfsm.info/Auto/Japan/Mazda/323/323F%20Mazda%20(89-94).pdf
Try looking near the distributor on the engine-block just below the head there should be a small square block extending out of the engine-block. The engine number will be located on it.
ollie Collinschange the oil, if no better will prob need a new valve body.
I think it was about 26.000 DEM, which is approximately €13.000. At least it was so in Macedonia when my dad bought it.
It says in the Mazda 323F owners manual to replace it every 100K km (60K miles) or 60 months whichever comes first
Clutches themselves typically run about 300-400. The labor may run to about 500-800 depending on where you are.
ford festiva, kia pride, Mazda 121Answerford festiva, kia pride, Mazda 121
If the car is using water and there does not seem to be a leak, it may have a blown headgasket. If you take it to a service centre they should be able to do a simple test to find out.
z5 (1.5) and bp (1.8) engine Ron 93+, 2.0l v6 Ron 95+
it starts but the oil light stay on
if u are runing i hot or one of he wires have a cut and its touching metal