0
Where is the iat sensor located on a 2001 pontiac grand prix gtp?
Wiki User
∙ 12y ago
It is located just before the mass air flow sensor on the rubber intake hose on top and right before the bend towards the intake aproximatly 3.5-4 inches befor the maf sensor
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Where is valve cover located on a 2001 Pontiac Grand-am 4-cylinder?
where is valve cover located on a 2001 Pontiac Grand-Am 4 cyl
What is the location of the iat sensor in a 2001 Pontiac grand am gt?
The sensor is located on the air intake duct. Between the air filter housing and the throttle body.
Where actually is the cam shaft sensor on a 2001 Pontiac Grand Am SE?
The sensor on the CAM SHAFT!
Where is the input speed control sensor located on a 2001 Pontiac sunfire?
The 2001 Pontiac sun fire speed control sensor is located on the front passenger wheel. The sensor can be found on the inside of the rotor.
2001 Pontiac grand prix output speed sensor location?
trasmission
Where is the crank shaft sensor located in a 2001 Pontiac Grand Prix?
most likely behind the plate covering the timing gears, at the front of the engine.
How do you replace the cooling fan sensor in a 2001 Pontiac Grand Am?
Cooling fans won't stop running in the cold on a grand am gt 2001
Where is the fuel filter located on a 2001 Pontiac Grand Am?
the fuel filter on a 2001 grand Am is behind the gas tank.
Why would a 2001 pontiac grand am turn over but not start?
Check the 2001 Grand Ams crank shaft position sensor first. If the sensor is bad then the engine will not get fire or start.
Where is the fuse box located on a 2001 Pontiac grand prix?
The 2001 Pontiac Grand Prix fuse box is located in the engine compartment. The fuse box will be on the back side of the battery box.
Where is the thermostat located on a 2001 Pontiac Grand Am 3.4L?
in the water pump
Where is the Crankshaft position sensor located on 2001 Pontiac grand prix 3.8l?
The crank shaft position sensor is located behind the harmonic balancer/crank shaft pully on the front of the engine. You can see the wires for the sensor run behinf the pully into a plastic housing.
