1991 through 1995 Explorers with the EEC- IV system have an external ignition control module in front of the battery mounted on the radiator support. 1996 and newer, the ignition control module is incorperated into the powertrain control module (PCM) for the EEC- V system.. The PCM is mounted in the firewall on the passenger side.
Buy a Haynes or Chilton manual for $15
A Haynes or Chilton manual will have detailed instructions on how to get that radiator out. I highly recommend that you pick one up. I think they're about $17.
Go to chilton.com, Chilton or Mitchell manuals may also be helpful.
My Chilton repair manual - engine wiring schematic shows ( 2 ) heated oxygen sensors for the 1993 Ford Explorer
( Fuse # 17 ) is a 15 amp fuse for the fuel gauge on a 1993 Ford Explorer according to my Chilton repair manual
Yes, you can find it Haynes or Chilton manuals for Toyota Camry 1999-2001.
According to my Chilton repair manual, it is in the fuse panel under the driver's side of the dash. Chilton shows a 15 amp fuse for dome courtesy light in location # 14
if you haven't already go to your nearest auto parts store and find a chilton manual for your vehicle.
Chilton Manuals are a good place to start - here's a link to the online version... http://www.chiltondiy.com/default.aspx
The radiator is in the front, directly behind the lower front grille. It sits about 5 inches off the ground. To replace or repair the radiator, you must remove the front grille, the fenders, and the front wheels. See a Chilton manual for complete details.
The spark plug gap for a 1994 Ford Explorer with the 4.0 L OHV motor is .052 to .056 range - Chilton repair manual shows .054
The address of the Chilton Public Library is: 221 Park St., Chilton, 53014 1433
Chilton Price's birth name is Chilton Searcy.
The vacuum hose diagram is located on the top radiator fan shroud. If the stickers not there, you can find it in a Haynes or Chilton book.
I looked at my Chilton repair manual and the engine wiring schematic for a 1994 Ford Explorer shows ( fuse # 17 - 15 amp - for fuel gauge )
According to my Chilton repair manual , the crankshaft position sensor is used to determine crankshaft position and crankshaft RPM
According to my Chilton repair manual : P1504 - idle air control (IAC) valve and / or circuit fault
The crankshaft position sensor is mounted on the front of the engine near the crankshaft pulley . Looking from the front it is to the left of the crankshaft pulley and is triggered by the teeth which are machined into the crankshaft damper (Chilton) You can see it from underneath the Explorer
Chilton, Texas is in Falls County.
Mary Chilton was born in 1607.
Mary Chilton died in 1679.
Henry Chilton died in 1954.
Henry Chilton was born in 1887.
Samuel Chilton died in 1867.
Samuel Chilton was born in 1805.