I have not worked on that particular vehicle but I have numerous years on GM vehicles of all kinds. The "Ignition Control Module" is located in the distributor. It looks like a small black wafer, usually has a 45 degree angle to it(so it fits), two small screws hold it in place and a wire connector at one end with the condensor unit plugged in the other. Easy to replace just make sure you use the electrical lubricant when installing.
Where is the ignition control module located in my 1992 Crown Victoria
ignition control module is located under the distributor cap
The 1994 Ford Aerostar ignition control module is located on the firewall in the engine compartment. The ignition control module will be on the drivers side of the firewall.
Crank sensor has failed,Ignition control module (ICM) has failed,Bad ignition coil pack,
Where is the control module located on the 1983 Chevy blazer
The Ignition Control Module on the 4 cyl models is located under the Distributor cap.
Where is the ignition control module on a 1987 nissan 300zx
The ignition module is located in the distributor, under the distributor cap.
it is located on the side of the air cleaners housing the one that say ignition control module in all chryslers car
1994 was the last year the Ranger used an ignition control module on the 2.3 and 2.5. The ignition control module was attached to the lower intake manifold.
The Ignition control module is located under the coil which is on top of the driver side wheel well, Commonly known as an ignitor.
the ignition control modual is located on the backside of the fuse box under the dashboard.
1997 Jeep no used LX235 ignition control module
where is the ignition module located on a 1988 Mazda b2200
the ignition control module is operated by the pcm,the pcm tells the ignition control module when to energize the coils to enable spark
The "brain" of the ignition system, the Ignition control module controls the ignition timing and strength, as directed by the main computer. It can be located in a variety of places, but it can normally be found underneath the hood.
The ignition module and coil are contained inside the distributor and are not serviced as separate parts.
That depends on the car. Most are under the hood in a electronics module box.
where is the ignition control module located on mercury marquis
The 1990 Chevy Celebrity engine is distributorless, the ignition is handled by a combination of the engine control module(computer) and the ignition control module. You did not mention which engine the car has. If your car has the 4 cylinder engine the ignition control module is below the intake manifold at the rear of the engine. You can follow the spark plug wires to it. The coils are mounted to the ignition control module. If your car has the V6 the ignition control module is near the starter and again you can follow the spark plug wires to it. Again the coils are mounted to the ignition control module.
3, all located ontop of the ignition control module.
The module is located underneath the coil packs.
Remove the wiring harness from your 1995 Chevy Blazer ignition control module. Remove the ignition control module retaining screws. Reverse the process to install your new ignition control module.