Top passenger side of the bell housing.
Top passenger side of the bell housing.
Top passenger side of the bell housing.
That sensor is located on the cylinder head, right next to where the ignition coils are bolted to the engine.
The cylinder position sensor is located in the distributor.
this is for a 2002 doge durango, it must be the sameLOCK CYLINDERREMOVALThe ignition key must be in the key cylinder for cylinder removal.# Disconnect negative cable from battery. # Remove upper and lower covers (shrouds) from steering column. # Place shifter in PARK position.# A retaining pin (Fig. 9) is located at side of key cylinder assembly. # Rotate key to RUN position. # Press in on retaining pin while pulling key cylinder from ignition switch.INSTALLATIONThe ignition key must be in the key cylinder for cylinder installation.# Install the key cylinder into the housing using care to align the end of the key cylinder with the ignition switch. # Push the key cylinder in until it clicks. # Replace the upper and lower shrouds. # Reconnect the battery.
New AnswerUsing your current key, insert it into the ignition & turn the ignition to the "On" position but not the "Start" position. Do not start the truck. Next, using a very small screwdriver (preferably a Phillips head) insert it into the hole located under the ignition key cylinder on the steering column.Pressing upwards with the small screwdriver or nail, you will press in the release button.Firmly grip the key & ignition cylinder while pressing up on this release button & remove while in the "On" position.Insert your new ignition cylinder with the key in it, into the "On" position until it snaps in place. Going in, the release button does not need to be depressed.You now have a Cylinder key, that will not match your door lock keys!Best of luck.
yes it can by removing the switch located on the door trim. however this indicates the cylinder is not in the Locked position. The cylinder must be fully turn counter clock wise. If it cant a new cylinder may be needed
it is located on the side of the transmission
The slave cylinder for your hydraulic clutch is located inside the manual transmission bellhousing
Yes it does. If it is a 4-Cylinder, it is on the transmission side of the engine cylinder head. If it is a V6, it is located on the transmission side of the front cylinder head.
It depends on where the slave cylinder is located. If it is inside the bell housing you will have to remove the transmission.
CAMSHAFT POSITION SENSOR IS LOCATED AT REAR OF CYLINDER HEAD ON BOTH THE 2.0 AND 2.4. IT'S FARTHER BACK THAN THE IGNITION COIL, HIGHER UP THAN THE ENGINE OIL PRESSURE SWITCH.
Ignition lock cylinder
The slave cylinder for a hydraulic clutch is located inside the manual transmission bellhousing