Starters and Ignition Systems
Chevy Corvette
Ford Escort LX

Where is the ignition module on a 1993 Chevy Corvette?

404142

Top Answer
User Avatar
Wiki User
2011-10-20 17:05:31
2011-10-20 17:05:31

The ignition module on a 93 corvette is bolted to the ignition coil bracket, which is located on the top/ front of the engine, passenger side.

Guy

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

A 1993 what, Ford, Chevy, GMC, Dodge, Kia, ???

User Avatar

The 1993 Hyundai ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.

User Avatar

The 1993 Ford Taurus ignition module is located behind the dashboard. The ignition module, can be found on the drivers side of the dashboard.

User Avatar

The ignition module that is in the distributor is probley bad.

User Avatar

the ignition module is under the distibutor cap

User Avatar

The ignition modual is in the front of the engine compartment, below the front manafold between the motor and the radiator above the starter

User Avatar

under the coil packs and the coil packs are connected to the spark plug wires

User Avatar

In the distributor,you need to remove the dist cap & then remove the rotor and it will be mounted to the distributor housing

User Avatar

where is a ignitionmodule in a dodge colt a 1993

User Avatar

where is the fuel located for ignition what number of the fuel

User Avatar

1993 "Glazer" had no ignition module. The Blazer however had one under the right front fender. The above answer is ALL wrong. Remove the distributor cap and rotor and you will see a electronic device that will have a electrical connector on each end of it and it will be bolted with 2 small screwes to the distributor plate.

User Avatar

IGNITION ? ARE we talking ignition coil-ignition wires ignition switch-key & tumbler.

User Avatar

A BAD CRANK SENSOR WILL CAUSE NO SPARK AND NO PULSE SIGNAL TO FUEL INJECTORS a bad ignition module will cause no spark its located under the ignition coil trio pack

User Avatar

The ignition module is under the ignition coils The coils are bolted to the frt of the transmission housing. Follow the ignition wires to the coils The coils are bolted to the module underneath The module control spark to the spark plugs. It sends the required signal to the coil as to when to fire t then fires and "sends" the spark through the ignition wire to the spark plug

User Avatar

Find your distributor cap and follow the center cable to a rectangular part. This is the ignition module. Remove it, get a new one and install it.

User Avatar

Could be the ignition module. It's attached to the side of the distributor.

User Avatar

will a 1985 corvette hood fit a 1993 corvette

User Avatar

The ignition timing on your vehicle is not adjustable. It is set according to driving conditions by the Powertrain Control Module, or PCM. There should be a sticker under the hood with this information.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.