On the Ford windstars they are in the rear passenger side behind a panel. It usually says on the outside of the panel where it is. It should be in the same place on the Mercurys. Ford also puts them on the kick panel of the passenger side of the front compartment also in other models. It should be one of the two places. It usually says fuel cut-off though. If you are talking about the inertia switch that is related to deploying air bags then it reads the speed decrease from the wheel speed sensors or from the transmission. Good luck.
its on the kick panel to the left of the clutch pedal
There is none as your Dodge is not equipped with an inertia switch.
Gm does not use inertia switches.
Plymouth vehicles do not use inertia/cut off switches.Plymouth vehicles do not use inertia/cut off switches.
Chrysler does not use inertia switches.
A 2000 Chevy Blazer is a GM vehicle. Vehicles made by GM do not come equipped with an inertia switch.
Yes, the 2000 Impala does have an inertia switch that is specifically for the fuel pump. The black thing with the red top next to the ball of the wiring under the kick panel is what is called the inertia switch.
where is the fuel pump inertia switch located on a 2000 blazer
GM doesn't use inertia switches.
Dodge does not use inertia/reset switches.
Inertia switch for the fuel pump? It doesn't have one.
Jeep does not use inertia/reset switches.
Dodge doesn't use inertia switches.
Dodge does not use inertia switches.
A 2000 Chrysler does not have a shutoff or reset switch.
On a 2000 Mercury Mystique : The fuel pump shut off switch ( inertia switch ) is in the drivers footwell behind the kick panel ( The interior trim panel in front of the door by the drivers left foot , there is an access hole through the panel )
Chevy did not use Inertia switches on there trucks.
On a 2000 Ford Windstar : ( Yes ) The fuel pump inertia switch ( shut off switch ) is located behind the service panel , in the cargo area , on the passenger side
Dodge doesn't use an inertia switch. The fuel system is computer controlled with relays.
On a 2000 Ford Crown Victoria : The fuel pump inertia switch ( shut off switch ) is in the trunk , behind the trunk liner on the drivers side ( there is an access hole )
On a 2000 Mercury Mountaineer : The fuel pump shut off switch ( inertia switch , which has a reset button on top of the switch ) is located in the front passenger footwell by ( or behind ) the kick panel * the kick panel is the interior trim panel , in front of the front door , beside the front passengers right foot *
the fuel inertia switch is located in the left kick panel which is located to the extreme left of the brake pedal
Is the " FUEL RESET " light in your dash on If the button has not popped up on the top of the inertia switch than the switch doe's not need to be reset
On a 2000 Lincoln Town Car : The fuel pump inertia switch is located in the trunk It is mounted on a bracket by the drivers side trunk lid hinge