answersLogoWhite

0


Best Answer

open the bonnet, alloy part bolted to the R/H side of engine is the inlet manifold. NOTE: IF you need to ask this question do not attempt any maintenence yourself.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the inlet manifold on a XH ford Ute 97?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Is the air temp sensor on the back of the inlet manifold on a 97 xh Ford Falcon ute?

assuming it's the 4 litre. yes it is. hard to change on the ground. easy to get from under the car.


Where is the IAT sensor in a 97 EL Ford Falcon?

the intake air temp sensor is in the inlet manifold


Where is the thermostat located on a 1997 ford explorer v6?

The 97 Ford Explorer thermostat is located inside of the engine inlet. The inlet is where the top radiator hose connects to the engine.


97 ford Club Wagon anti-freeze leak from your motor?

I have a 97 Ford Club Wagon van. there is anti-freeze leaking from the manifold right above the gasket ( it look like the circle imprint on the manifold. How can this be fix?


97 Ford Escort what is the fuel inlet tube?

It's the fuel rail that feeds gas to the injectors.


Where is the car starter in 97 Ford Expedition?

Passenger side near the firewall under the exhaust manifold


Where are the o2 sensors located on 97 ford explorer?

The O2 sensor on any vechicle will be located on the exhaust manifold.


Where is th o2 censer on a 97 ford escort?

There should be 2 1 in the exhust manifold and 1 after the cat converter


Where is ignition coil 4 on a 97 ford f-150 5.4?

On the intake manifold, there should be one for each cylinder. It helps start the vehicle, it makes the spark that ignites the fuel in the manifold.


Was the 97 trademan ute supplied with the tickford engine?

yes*i-own-one


1997 ford f150 wont start?

i had the problem with my 97 f150, the power wire to the computer had melted on the manifold and had to be replaced, check the wire to see if its grounding out


What are the tappet settings on a 97 1.3 fiesta?

Inlet 0.20 exhaust 0.30