answersLogoWhite
Ford Escort LX
Grand Am GT
Late Model 1979-New Ford Mustangs

Where is the intake temperature sensor located and a 2002 grand am gt?

234

Top Answer
User Avatar
Wiki User
Answered 2008-04-03 07:06:39

If you look on the hose going from the air filter box into the engine the AIT sensor is screwed into the side of the hose

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Your Answer

Related Questions


IAT sensor (intake air temperature) or more commonly known as the MAT (manifold air temperature) sensor is located on either the air intake snorkel or the manifold



Answerthe intake air temp sensor is located in the air duck.probably right after the air filter box.


It should be located on the air intake hose before the Mass Air Flow Sensor. Hope this helps.RR Of The Engine Compartment




Intake Air Temp Sensor It should be located on the intake or close to the throttle body


It is located behind the IAC which is bolted to the Throtle-body. Remove the air intake connection to see better, take the electrical connector off and unscrew the sensor from the intake manifold


The Intake Air Tempature sensor is located on the air intake duct about mid way down the duct.


It's under the air intake on the thermostat bellhousing.



i have a 1999 grand am se with a 3400 sfi and it's under air intake on the thermostat bellhousing hope this help you out. good luck


This sensor is located on the air intake track. This sensor will only have two wires coming from itÊandÊthis sensor is also called the throttle body.



The IAT is part of the MAP sensor on vans before 2001. In 2001 they started putting it near the air box.


were is the cooling temperature sensor located on my 96 Plymouth grand voyager


The fluid temperature sensor is located on the left side of the transaxle. It is held in by a single bolt.


The AIT sensor is located on the plastic tube that runs from your air filter box to your engine intake throttle body. There is a two wire plug that attaches to the sensor. It is visible as soon a you open the hood on the right side of the engine bay.


The coolant temperature sensor on a 2001 Jeep Grand Cherokee is located on the T-stat. It is on the passenger side of the Jeep.


The error code p1193 on a 2001 Dodge Grand Caravan indicates that the intake air temperature sensor has failed. The sensor can be replaced by unbolting it, removing the wiring harness, and pulling it from the intake.


disconnect the temperature sensor located under air intake , on thermostat bell housing that should automatically turn on the fans


Answeron what? on a 2002 grand am it is right on top of the big black tube coming from the air filter to the engine


this is the only sensor on the air duct between throttle body and air filter housing.


The 1994 Jeep Grand Cherokee IAT sensor can be found attached to the air intake hose. The IAT sensor will be near the air filter box.


It is located just before the mass air flow sensor on the rubber intake hose on top and right before the bend towards the intake aproximatly 3.5-4 inches befor the maf sensor



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.