answersLogoWhite

0


Best Answer

Underneath the intake manifold there will be two knock sensors

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the knock sensor for a 2000 camaro ss located?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the knock sensor on a 2000 Camaro Z28?

under the manifold, there are two (2)


Where is the knock sensor located on a 2000 g20 infiniti?

i need to locate knock sensor on a 2000 infiniti g20


Where is the knock sensor located on a 2000 Blazer?

The knock sensor is basically a one inch thick washer with a sensor plug on it. it will be attached to the block with a bolt that just runs through the center of it The knock sensor module is located inside the little cover on the VCM.


Where is knock sensor located on 2000 Chevrolet Malibu 3.1?

On V6 models, the knock sensor is located on the front (radiator) side of the engine block above the oil filter.


Where knock sensor located in Honda accord 2000 model?

by oil filter


Where is the knock sensor located on a 2000 kia?

The knock sensor is on the right side of the motor on the block .It runs under the manafold.I can not get the retaining clip off.MIKE


Where is the knock sensor in a 2000 Monte Carlo SS?

The knock sensor is located on the front (radiator) side of the engine block above the oil filter The knock sensor is located on the front (radiator) side of the engine block above the oil filter


Where is the Knock Sensor located in a 2000 Subaru Outback Legacy?

It is located on the engine block drivers side.


Where is the knock sensor located on 2000 gmc jimmy 4x4 v6 vortech engine?

2000 jimmy 4.3ltr v6. were is the o2 sensor bank 1, sensor 3


How do you install the knock sensor in a 2000 Monte Carlo?

Where is the knock sensor on a 2000 monti carlo ss 3.8l


Knock sensor located for 2000 Honda civic ex?

Near the spark plug #2


Where is the knock sensor located in a 2000 Alero?

It's located outside the drivers door. First, you must determine who is knocking on your door. Then after that you can open the door to reveal the knock sensor or if it is a manual knock sensor roll down the window and simply say "Hello" to the knocker. Hope this helps.