Bank 2 is the drivers side of the engine in your Ford Explorer Sensor 2 is after the catalytic converter ( downstream )
There is no knock sensor on a 94 4L jeep engine. In 1991 when they changed to the 4L HO motor, they removed the knock sensor from the system.
its located in your MAF on the air intake ========================================================== The Mass Air Flow sensor is located between the engine air filter housing and the engine air intake tube on your 2004 Ford Explorer Sport Trac
what engine size
Where is the cabin filter located on an Ford Explorer Sport Trac 2008?
The MAF sensor is always located in the ductwork between the air filter box and the throttle body.
It is not a simple sensor. It is a part of a pipe. Look for this part number: 9E616. It is located over the fuel tank.
The ABS Sensor is located inside of the hub, which is replacable only by replacing the entire hub assembly as a unit.
On your Ford Explorer Sport , 4.0 EFI : Bank 2 is the drivers side of the engine Sensor 1 would be close to the engine ( it might even be in the outlet of the exhaust manifold ) BEFORE the exhaust enters the catalytic converter
Its part of the MAF sensor. In 98 they integrated it.
Were is fuel injector located on a 1999 ford explorer
Bank 2 is the drivers side of the engine on your Ford Explorer Bank 2 / Sensor 1 is in the exhaust manifold or the exhaust pipe before the exhaust enters the catalytic converter
On your 1998 Ford Explorer Sport : The mass air flow sensor is between your engine air filter and the big rubber engine air intake tube
where the ford symbol is
The door ajar switch is located on the backside of the door latch assembly, and is accessed inside the door by removing the door trim panel.
The intake air temperature sensor is connected to the mass airflow sensor as one unit, it's at the beginning of the air intake tube just after the air cleaner. The sensor with six wires running out of it
Its integrated into the MAF sensor as of 1998.
Bank 1 is the passenger side of the engine in a Ford Explorer Sensor 2 is in the exhaust after the catalytic converter ( downstream )
the Intake Air Temperature (IAT) sensor is located in the air cleaner to throttle body supply tube ( big rubber tube ) close to the engine throttle body.
The 1998 Montero Sport crankshaft sensor will be located on the rear of the engine. The crankshaft sensor is on the inside of the rear engine cover.
The oil drain valve on a 2000 Ford Explorer Sport is located near the rear of the oil pan. The radiator drain petcock is located at the bottom the radiator.
Between the engine air filter housing and the big rubber engine air intake tube
The camshaft position sensor on the 1999 4.0 L OHV engine is located at the rear of the engine block on the top of the engine where the distributor was installed on earlier versions of this engine. (according to my Haynes repair manual)
On my 2001 sport trac it is behjnd the backseat on the module