can you tell me where the knock sensor is located on a 3.3l mercury villager
It is the intake air temperature sensor , and it,s located in the air intake boot.
on my 1999 ford mercury villager its on top of transmission under the van
Intake Air Temperature Sensor. Located in the plastic air intake tube beside the battery.
In the engine compartment
It is located in the distributor unit.
On the EGR valve assembly.
It is mounted to the rear of the throttle body.
There is no such part that I am aware of.
1999 - 2002.
Mass air flow sensor is mounted after the air filter.
Cam position is taken from the distributor. There is no separate cam sensor.
The MAP sensor should be on the firewall just above the brake booster.
on the throttle body on the throttle body
On the firewall near the brake master cylinder.
In a 1998 Mercury Villager, the mass air flow sensor is located in the air intake tube. The air intake tube goes from the air box to the intake.
the elictronic control sinsor at on a 93 mercury villager
Cam position is taken from the distributor on this vehicle, there is no separate cam sensor.
O2 sensors are always located on the exhaust system.
The VSS is located on the bottom of the transaxle beside the exhaust manifold.
Located in the air intake tube beside the battery.
The cam sensor on a 1996 Mercury Villager cost about $35 to $40. The sensor is actually manufactured by a Nissan subsidiary.
The Vehicle Speed Sensor on the 1996 Mercury Villager is located on the back of the transmission (as you look at the vehicle from the front) on top of the transmission with a pair of wires leading away from it... best to reach it from under the vehicle.
The CKP sensor is located on the left side of the engine compartment on the transaxle housing.
Sensor 2 is in the exhaust pipe under the passenger seat area.