answersLogoWhite
Car Computers and Sensors
Chevy Silverado
Buick Regal
Nissan Maxima

Where is the knock sensor located on a 91 Buick Regal Limited with a 3800?

303132

Top Answer
User Avatar
Wiki User
Answered
2005-09-28 23:53:41
2005-09-28 23:53:41

Possibly located on passenger side of engine below and slightly to the left of the water pump.

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Where is the knock sensor located on a 1992 buick regal



The crankshaft position sensor, on your 1992 Buick regal 3.1 liter, is located on the back of the engine. The crankshaft position sensor is on the inside of the engine cover.


Where is the map sensor on a 2001 Buick Regal Ls


Where is the headlight sensor for a 1999 buick regal? Its in the back, sike ;D


The ignition fuses for the 1993 1993 Buick Regal 3800 is located on the car's dashboard.


The cam sensor on a 99 Buick Regal is located behind the rear cam bearing cap. It monitors the rotation of the cam and relays information to the vehicle's computer.


On a 1993 Buick Regal 3.1L, the PCV valve is located on the intake manifold. It is situated underneath the MAP sensor.


where is the thermostat located on 95 buick regal


The Sensor for the fans is located on the upper right side of the radiator, ( the Passenger side).




The camshaft position sensor on a 1992 Buick Regal looks like the end of a ratchet.


The 2000 Buick Regal 3.8L Crankshaft Position Sensor is located behind the harmonic balancer pulley.



Coolant Recovery Reservoir. There is no sensor in the coolant recovery tank on a 1998 Buick Regal.


On a 1993 buick regal it is on the passager side of the radiator. Hope this helps


I believe that one is under the car near the gas tank.


How do you replace the fuel filter on a 2003 Buick Regal?


The temp sensor is behind the front bumper. It is a small black probe with two wires going to it.


how to remove crankshaft position sensor from 91 Buick Regal



The crankshaft sensor is located behind the harmonic balacer. you will need a puller with special bolts to remove the balancer.


I have a 1991 Buick LeSabre and I believe its on the passenger side in between the firewall and engine. I believe it becomes more accessible if you take off the right front wheel and then remove the wheel well plastic shroud.


where is the 91 vandura G2500 Instrument Panel Cluster Relay located :milsunworld@yahoo.com



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.