Nissan Maxima
Nissan Pathfinder
Nissan Quest

Where is the knock sensor located on a Nissan Pathfinder?

222324

Top Answer
User Avatar
Wiki User
2009-10-17 18:22:55
2009-10-17 18:22:55

everyone one is telling me it is located under the intake or intake manifold, and that if must be removed..

12
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

how you can remove the knock sensor from a 1996 Nissan pathfinder i need a picture

User Avatar

You can find a 1996 Nissan Pathfinder knock sensor picture in most auto repair manuals. Most Nissan dealerships repair centers will provide you with a picture of the sensor.

User Avatar

The knock sensor for most Nissan V6 engines is located directly under the intake manifold. So to replace it, you have to remove the intake manifold. Good Luck.

User Avatar

Where is the knock sensor for a 99 pathfinder

User Avatar

The knock sensor is located below the intake manifold

User Avatar

The knock sensor is located below the intake manifold

User Avatar

No, That part will not shut the engine down

User Avatar

where is the knock located on 2001 nissan altima 2.4

User Avatar

The knock sensor is located below the intake manifold

User Avatar

Th knock sensor on a 2002 Nissan Xterra 3.3 is located on the top of the engine. It is mounted under the engine intake.

User Avatar

The knock sensor on a 2001 Nissan Sentra is located on top of the engine, near the exhaust manifold. It detects abnormalities in the ignition and combustion cycle.

User Avatar

The knock sensor is located below the intake manifold

User Avatar

Knock sensorThe knock sensor for a 1996 Nissan Altima is located on the backside of the block above the oil filter.But before you go and change it out, run a tank of the best/hightest rated gas you can find and see if that fixes the problem. On my 1995 the Knock sensor is located under the plenum and intake manifold on top of the middle of the block.

User Avatar

I bought one off the internet for around $50, but found out it cost about $450 in labor to have it replaced.

User Avatar

The detonation sensor ( knock sensor ) really cannot be checked by the home mechanic it is either good or bad. It consists of a pressure sensing piezoelectric element that converts pressure differences into electrical signals that can be read by the computer.

User Avatar

the Knock sensor is located behind the Harmonic balancer pulley. on the bottom sidethe sensor is $95.00 remove the lock down screw unplug and replace

User Avatar

A knock sensor is located in a specific area on the block or cylinder head in order to sense spark knock occuring and send a signal to the ECM to retard the timing. Relocating the knock sensor would defeat its purpose.

User Avatar

center of the engine near the top. It is going to be by the heads.

User Avatar

Your knock sensor is located undernesth the air intake manifold on top of the engine block. This goes for 2000-2004 xterra V6 3.3L models. Hope this helps.

User Avatar

can you tell me where the knock sensor is located on a 3.3l mercury villager

User Avatar

It is located unter the intake manifold near the oil filter.

User Avatar

the knock sensor is located under the intake manifold, with a flash light you can see it however you have to remove the intake manifold to replace the knock sensor , also you will need to replace the intake gasket set as well!

User Avatar

Where is the knock sensor located on impala SS

User Avatar

Where is the Knock Sensor located on a 1996 Oldsmobile Aurora?

User Avatar

where is a knock sensor located on a 96 Pontiac Bonneville


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.