It is on the passenger side of the engine just in front of the starter. It is round and has an electric wire pluged in the end of it. It is screewed into the water jacket in the side of the block.
The 1990 Chevrolet Corvette IAT sensor does have two wires. The sensor has a ground wire and a positive wire.
where is the knock sensor circuit #1 location on a 1999 trans am ls1, I have looked everywhere. thanks
LS does not have a knock sensor. GSR does have a knock sensor
The coolant fan switch is located close to the thermostat.
It is in front of the starter on my van.1990 350
it's located under the intake manifold. the knock sensor is most likely ok' the porblem is the short wiring harness from sensor to main wire harness.
oil pressure switch or knock sensor
It is screewed in the engine block over by the starter.
The knock sensor detects spark knock or ping.
The knock sensor on Nissan 300ZX non-turbo from 1990 thru 1996 is located below the lower intake manifold on the rear of the engine block. To replace the knock sensor the upper and lower intake manifolds need to be removed. It is always best to replace the knock sensor with a new one considering its major dissasembly.
It is screwed into the water jacket on the side of the engine block just in front of the starter. It is HARD to see. It will have an electrical connector plugged into it.
Where is the knock sensor for a 99 pathfinder