If it's a 2.4L engine its on the backside of the engine block (the side of the firewall) directly under the manifold accessible from under the car.
Knock sensorThe knock sensor for a 1996 Nissan Altima is located on the backside of the block above the oil filter.But before you go and change it out, run a tank of the best/hightest rated gas you can find and see if that fixes the problem. On my 1995 the Knock sensor is located under the plenum and intake manifold on top of the middle of the block.
I don't believe that the altima had a crankshaft position sensor until 1995.
I don't believe that the altima had a crankshaft position sensor until 1995.
The 1995 Nissan: temperature sensor is located on the front of the engine. The coolant temperature sensor will be near the thermostat housing.
I don't believe that the altima had a crankshaft position sensor until 1995.
no. didn't come out until 1995
The Camshaft sensor is located under the cap and rotor of the distributor. This is a common failure on the 2.4L engine due to oil leakage into the distributor. how is the camshaft sensor replaced on 1995 Nissan altima. what other considerations are there.
there are two wires
There is no error code PO329 for a Nissan Altima. The closest codes for this would be P0335 which is the CKP Sensor or P0340 which is the CMP Sensor, Detectable Or Undetectable Circuit.
how do you reset the oil light on a 2000 altima
No its completely different.You can see the difference at jlkautoparts.
ok