Chevy Silverado
Lincoln Continental
Ford Expedition XLT
Ford Explorer XLT

Where is the location of the oil sending unit for a 1994 Lincoln Continental with a 3.6 ltr fuel injected engine?

333435

Top Answer
User Avatar
Wiki User
2005-11-04 04:22:49
2005-11-04 04:22:49

On most ford vehicles and most vehicles in general the pil pressure sending unit is located near the oil filter. Find your oil filter and feel around it particularly above it. This would probably be the only place where you would find the sender because it is the best place to put it. Just look above the oil filter and try to find a fitting with some wires protruding from it, you have found your oil pressure sender. I hope I helped

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

where is the oil sending located on a 1993 Lincoln town car? where would i find a discriptive picture of the of a 1993 Lincoln town car

User Avatar

The oil pressure sending unit is located on the engine block, under the power steering pump. It is only accessible after the steering pump has been removed.

User Avatar

It's located under the power steering pump. In order to get to it you have to take the power steering pump off.

User Avatar

location of oil level sending unit 6.6 disel

User Avatar

The temperature sending unit on a 1994 Lincoln Town Car is on the top front of the engine. It is directly in front of the distributor.

User Avatar

I am looking for the location of the oil sending switch on a 2000 F150, or where I can see a diagram or picture of it. Thank You

User Avatar

The oil sending unit is located next to the oil filter...

User Avatar

because they wanted to go to war and if they died they would have a back up by sending the olive branch and they wouldn't get in trouble

User Avatar

Lincoln communicated by speaking to people directly, writing letters, and sending telegrams.

User Avatar

The postage is the same as if you were sending within the continental US.

User Avatar

On your 4.0 L - OHV engine , the oil pressure sending unit is on the drivers side of the engine , below the power steering pump

User Avatar

Most 1991 sending units on a 1991 Le Sabre screw in. The exact location for the sending unit will depend on which one needs changing.

User Avatar

either replace the sending unit or the dash gauge, that is if there is electricity getting to the sending unit.

User Avatar

The oil pressure sending unit on the 4.7L engine is right above the oil filter.

User Avatar

Are you refering to the Temperature Gauge Sending UnitThe sending unit is located in the front section of the intake manifold in the vicinity of the thermostat.

User Avatar

This is located inside your vehicle beneath the drives door

User Avatar

The Chrysler Town and Country speedometer sending unit is located on the back of the transmission. The sending unit will be in the upper right-hand corner of the transmission.

User Avatar

Temperature Gauge Sending Unit The sending unit is located in the front section of the intake manifold in the vicinity of the thermostat.

User Avatar

The oil sending unit is located on the back of the block, directly behind/below the distributor.

User Avatar

Temperature Gauge Sending Unit The sending unit is located in the front section of the manifold in the vicinity of the thermostat.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.