answersLogoWhite

0


Best Answer
Copy

usally by the oil filter or top of motor at the back Rooterman2.

User Avatar

Wiki User

โˆ™ 2007-08-26 04:42:20
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: Where is the location of the oil sending unit on a 1988 Ford F-250 pickup with a 460 engine?
Write your answer...
Submit

Related Questions

Where is the location of the oil sending unit on a 1988 Chevy pickup?

It is behind the distributor, and screewed into the top of the engine block


Location of oil sending unit on a 1988 Chevy pickup c1500?

It is right behind the Distributor and screewed into the top of the engine block.


Location of the 1 cylinder on a 1988 4.3 engine in a gm 1500 pickup?

Driver's side closest to the front


Location of starter on 1988 S-10 pickup?

standing in the front of the engine, it will be on the left bottom rear side of the engine towards the back.


Can you swap the engine from a 1988 Nissan pickup to a 1984 Nissan pickup?

no 84 and 85 swap out.


Is the 350 engine from a 1995 pickup a direct swap with that of a 1988 pickup?

Yes it is, There is no difference in the 2 engines.


Where is the 1988 Chevy engine control module?

In a 1988 Chevy pickup the ECM is located behind the glovebox.


How much engine oil is needed for a 1988 Nissan pickup?

4.5 qts.


Where is the voltage regulator in a 1988 Dodge Ram Pickup with V8 Engine?

Built in the alternator


Where is the oil filter on a 1988 GMC S15 pickup?

on the engine look around you will find it


How big is the gas tank on a 1988 Toyota pickup with a 22re engine?

17.2 gallons


What type of oil do you use in a 1988 dodge ram pickup with a 318 engine?

10w30


How do you reset service engine light for 1988 Chevy pickup?

disconnect the battery for a few minutes


Can you swap a 454 engine in a 1988 Chevy pickup with a 350 engine?

Yes. The exhaust is different, and you'll need a bigger radiator.


What are the tune up specs on a 1988 Ford E-350 with a 460 engine?

what are the carb settings fro a 1988 f350 pickup


What is the sending unit for on the passenger side of the engine block on a 1988 suburban?

If it has a computer it is the knock sensor.


Will a 1996 Chevy Tahoe 350 engine fit a 1988 Chevy pickup?

Yes but modification will be needed


What time of oil do you use on a 1988 Chevy pickup with a 305 engine in it?

your OWNERS MANUAL will tell you' if you can read, that 5W30 is the required viscosity for the engine


Where is oil sending unit on 1988 ford f 150?

The Oil Sending Unit is directly in front of the oil filter on the 302 (5.0) V8 engine.


Where is the oil sending unit on a 1988 dodge Dakota 3.9L?

It is on the back of the engine, next to the distributor.


Where is the oil pressure sending unit located on a 1988 Chevy s10?

At the rearmost section of the engine to the right of the distributor.


How do you remove the oil sending unit on a 1988 dodge 3.8 liter engine?

Remove wire and unscrew counterclockwise


Where is the oil sending unit on a 1988 Chevy Astro Van located?

rear drivers side engine block


Where can you find a wiring diagram for the distributor for a 1988 GMC 2500 Pickup with a 5.7 liter engine?

you might try www.haynes.com


Will the engine from a 1990 Chevy Suburban fit in a 1988 Chevy pickup?

YES, They are the same engines. That would be a direct bolt in.