on a 1998 Pontiac gan am ,they do not have a pcv valve.
The warning lights on a 1998 Pontiac Grand Am mean that the vehicle's computer has detected a problem. This can range from low tire pressure to malfunctions within the engine itself.
Where is the starter on a 1998 Pontiac Grand Am, 6 cylinder
drive cycle for 1998 pontiac grand prix, 3.8 engine, no super charge?
how do you change a brake booster valve to a 1998 Pontiac transport
The weep (overflow) hole cannot be closed on a 1998 Pontiac Grand Am 2.4 liter. This hole is there so that the engine can let off pressure when things get a little too warm. It keeps the engine from overheating.
yes as long as the grand am is a 2.4 twin cam also
I have a 1998 Pontiac Grand AM GT that coolant sensor went bad. So how do you change it with out breaking the coolant
I think they are also refering to a fuel pressure regulator but not sure.
You can easily get all of the color codes for every wire on the 1998 Pontiac Grand Prix. Pontiac has an official website homepage that has all the information on it.
Usually located on the accumulator at the rear of engine compartment on passenger side
where is the location of the body control module on a 1998 grand am se
All 1985-1998 Pontiac Grand Ams take 19" replacement windshield wiper blades on both sides front.
looks like there is a coolant bleed valve on top of the water pump casting on top of a 2 inch high PC of metal tubing one small needle valve with a 6mm hex nut
where is the heater control valve
If it looks the same it will probably work.
The torque of the 1998 Pontiac Grand Prix is 220 ft.-lbs. at 4000 rpm. This remained the standard for all sixth generation models of this car.
i got no idea
This website has one. http://www.devicemanuals.com/guide/Automobile/Pontiac/Pontiac-Grand-Prix-Owner%27s-Manual-1998-==TVRFd01qSXc=.html
The 1998 Dodge Grand Caravan 3.8 liter engine EGR valve can be found on the top of the engine. The EGR valve will be near the back of the engine.
had this promblem before check the catalytic converter it must be blocked,check the back pressure
Part of the pump module in the tank.