It is on a bracket mounted on the passager side of the intake manifold right above the valve cover. Its black and has a vaccum line and a electric plug on it. NEUTZ
There are two of them located in the block under the intake manifold.
From a Chevy Dealer.
The 1992 Chevy 5.7 liter engine IAT sensor can be found on the back of the engine. The IAT sensor will be near the top of the transmission.
The one after the catalytic converter.
The map sensor for a Chevy 5.3 liter engine is on the top of the intake. It is at the back of the engine.
under the intake manifold
the throttle positioning sensor is located under the gas petal on the side of the bracket that the petal bar is attached to
The 1999 Chevy Lumina 3.1 liter engine crankshaft position sensor is located on the back of the crankshaft. A diagram can be obtained from most Chevrolet dealerships.
Remove the distributor cap and rotor. It is the only electronic device that you will see. The cam sensor.
Chevy did not use a crank sensor on that year.
By the Oil Filter, underneeth the intake manifold.
it is in the distributor
There is two of them. They are located under the intake manifold. There is two of them. They are located under the intake manifold.
It is located on the frame just forward of the gas tank.
Some of the Chevy Blazers were made without the crankshaft sensor. You should have a cam sensor that works the same way. It is located on the passenger side under the 2nd spark plug from the front.
Is this a 3.1 liter engine? tipicaly by the throttle body area. idle sensor or idle air controll valve?
The 1999 4.7 liter engine temperature sensor is located just above the thermostat housing. The sensor will be on the front of the engine.
Where is located
The cam sensor is the distributor.
the knock sensors 1 and or front and back are locaded under the intake
It does not have 1.
it's located on the top underneath the rotor of the distributor
It is built into the mass air flow sensor.
The camshaft position sensor is a part of the distributer. There are 2 electrical plugs going to it, 1 is for the coil,the other is for the Camshaft sensor.