it is mounted to the strut tower between it and the firewall on the passenger side
Where is the flasher relay on the 1999 mazda protege
where is the thermostat on a 1999 mazda protege?
you needs a dpfe sensor
Yes, 1999 Mazda protege window issues indeed....
Inside the fuel tank
99 mazda b3000 where is the speed sensor located
the altenater is located on the bottom, closest to the fire wall
thermostat is located where the lower hose conects to the engine
its inside the transmission by the oil pan
The speed sensor is located on the rear axle housing.
in the stearing wheel
You can use the end of the tire iron to remove the lug bolts off a 1999 Mazda Protege DX.
on the tranny
Yes it does have ABS. The older Protege 1997 and older dosnt.
whar are the torque specs for head bolt on a 1999 Mazda protege 1.6 engine
The only fuel filter on the 1999 Protege is a "sock" on the fuel pump pickup tube inside the gas tank. The sock can't be replaced seperately from Mazda, you have to replace the fuel pump which does not include the sending unit.
The idle air control valve is also known as the idle speed valve. On a 1999 1.6 literÊMazda Protege, it is located at next to the throttle body.Ê
under the trottle body
12.5mm
Yes, they are only good for either 60,000 or 100,000 mile depending on which type was used.
The 1999 Mazda Protege DLC fuse can be found in the fuse box. The DLC fuse will be at the bottom of the first column.
i think it does nt have one
There are O2 sensors on the 99 1.6L Protege I don't know about the 1.8L. The 1st one is located at the top of the exhaust manifold where it comes off the engine. The 2nd is located about a foot down the manifold from the 1st. They are not cheap to replace I suggest you know witch one is bad before you replace it.
If a 1999 Mazda Protege keeps making clicking noises, you might have a bad alternator or starter. You could also have a bad ignition or solenoid.
No , the 1.8 liter 4 cylinder in a 1999 Mazda Protege is not an interference engine