Chevy Silverado
Subaru Legacy
Ford Ranger XLT

Where is the map sensor on 1995 Subaru legacy l wagon?

222324

Top Answer
User Avatar
Wiki User
2008-01-23 09:20:58
2008-01-23 09:20:58

The Map sensor, (Subaru simply calls it a "pressure sensor") is located on the passenger side on the strut tower facing the Air cleaner.(US cars). The part itself has a 3 wire connector, and a single vacuum hose coming out of it. The part is about 1 1/2 inches wide and utilizes 2 mounting bolt holes. Take note that only "one" of these holes is used for mounting.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

it should be right under the stearing wheel. . . that is where mine is in my 1995 Subaru wagon.

User Avatar

I would like to know how to fix my 1995 subaru legacy wagon 5 speed manua transmission, or if anyone knows or have the electrical wiring and electrical diagram for 1995 subaru legacy 5 speed manua transmission ? Thanks

User Avatar

There is no such thing as a 1995 subaru outback, the outback package was not offered on a subaru legacy until 1996, you either have a 1996 subaru outback, or you have a 1995 subaru Legacy L or LSI wagon. Both will be covered in most guide books you can pick up at your local autoparts store.

User Avatar

If a bolt is stripped on the windshield wiper on a 1995 Subaru Legacy Wagon, there are two options. A person can go to a salvage yard and purchase new wipers for the vehicle, or they can have the bolt hole tapped for a larger bolt.

User Avatar

My '95 Subaru Legacy Wagon averages between 23 - 24 mpg in mixed driving. Pure highway, I push 28. HOPE THIS HELPS.

User Avatar

The spark plug gap for a 1995 Subaru Legacy is .044"

User Avatar

http://www.lovehorsepower.com/SubaruDocs/CoolantTempSensor.htmlits a 1995 but same thing

User Avatar

I own a 95 Legacy wagon and when my fuel light comes on and I fill it up I usualy have about 4 gal left in the tank cause it takes me about 11.5 gal to fill it. I have been getting about 20 mpg around town.

User Avatar

The IAT is located in the air intake duct. First, find the intake air hose, and then follow that to the sensor, which should be located with the mass air flow sensor if it is double?รฆoverhead cam engine.

User Avatar

A flashing CEL means a serious problem, not just a warning. Get it read asap. You might not even want to drive it there.

User Avatar

Will fit Legacy/Outback Model Year 1995 to 1999.

User Avatar

AnswerIf it has a governor it is part of the ECM and it watches the vehicle speed sensor and will cut-off fuel and spark at a level determined by OEM.

User Avatar

I believe they only made the 2.0tt in 1995

User Avatar

The most common fault with any blower motors not working is usally the resistor switch which is located in the heater box its self. Richard @ Allander motors

User Avatar

More likely u-joints if only when shaft turns.

User Avatar

Inside the fuel tank, To get to the fuel pump you must remove the back seat on the sedan or if it is a wagon remove the carpet on the back floor-same on a sedan, There will be an oval plate- remove it , The fuel pump is right there.

User Avatar

5 quarts dry engine - 4.5 quarts for an oil change.

User Avatar

AutoZone.com has a tab that will give component locations of many parts including relays


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.