answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2011-09-13 10:58:19
Camry MAF location(from 1999 Australian built Camry).....try on top of the air filter intake box, There is about a 6inch length of 3inch diameter intake piping that is a moulded part of the filter box assembly (top) .

On the side of the piping is a oblong box that houses the MAF sensor (it has a connector with 5 wires plugged into it).

if this doesn't help I can send you a photo (can't seem to post it here though)

S

001
๐ŸŒŽ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Loading...

Still Have Questions?

Related Questions

Where on 1998 toyota camry is the vehicle speed sensor located?

Under the hood


Where is the air flow sensor 1998 Toyota Camry LE?

The air flow sensor is located inside the air box of a 1998 Toyota Camry LE. To replace the unit the air box screws must be unmounted and the sensor disconnected.


Where is the knock sensor located 1998 Toyota Camry?

Knock sensor is located in the wall of the engine block facing the firewall. You have lift the car if you want to reach it.


Where is the throttle position sensor located on a 1998 Toyota Camry?

Throttle position sensor is located at the throttle body. There are only two sensors there. The one facing the firewall is what you are looking for.


Where do you plug the obd2 sensor in for a 1998 Toyota Camry?

On Camry 1998 all sensors are OBD 2 because it's a standard. You need to specify which sensor you are talking about.


Would a 1998 Toyota Camry motor fit in a 1999 Toyota Camry?

Will a 1998 Toyota Camry motor fit in a 1999 Toyota Camry


How do you reset the light sensor on a 1998 Toyota Camry?

Replace the bulb that is burnt out.


Where is the camshaft position sensor located on a 4-cylinder 1998 Toyota Camry?

It's next to the timing belt gear. The sensor can be accessed from the the firewall side.


Where is the blend door actuator located in a 1998 Toyota Camry?

where is the blend door machanism (acuator) located in my 1998 toyota camryalso how to fix


How much hp does a Toyota Camry 1998 v6 have?

The 1998 Toyota Camry V6 has about 150HP


Will a 1995 Toyota Camry motor fit in a 1998 Toyota Camry?

No, it will not.


Where is the oxygen sensor 1 bank 1 on a Toyota Camry?

I have toyta camry 1998 so I woud like knol werhere is the o2 sensor bank senor 1?


Where is the oxygen sensor located in a 1998 Camry?

In the ex pipe close to the manifold.


Where is the map sensor located on a 1998 Toyota RAV4?

The map sensor comes standard on a 1998 Toyota Rav4. It is typically located on the dashboard panel on the drivers side of the car.


Need a diagram of a 1998 Toyota Camry timing chain?

Toyota Camry 1998 has a timing belt.


How do you change a charcoal canister for 1998 Toyota Camry?

how to removed charcoal canister for toyota camry 1998 6cyc


Where is the camshaft sensor located on a 4cyl 1998 Toyota Camry?

The Camshaft Sensor on the 5S-FE engine it located on the back of the cylinder head (facing the firewall) next to the back of the timing cover. It is fastened to the cylinder head with a 10mm bolt.


Where is the engine coolant temperature sensor on a 1998 Camry located?

V 6 300


Where is the iat sensor on a 1998 Toyota Camry 4-cylinder?

Look on the rear of the air filter enclosure.


Where is ECU located on a 1998 Toyota Camry XLE?

You can find the ECU behind the glove box.


How do you replace serpentine belt for 1998 Toyota Camry?

The 1998 Camry did not have a serpentine belt. Do you have a 1998 Corolla?


How to replace air vent switch for a 1998 Toyota Camry?

how to install replace air intake hose toyota camry 1998


Where is the diagnostic port located on a 1998 Toyota Camry?

OBDII Port below dash/steering wheel.


Where are the air bag sensors located for a 1998 Toyota Camry?

Should be somewhere in the front bumper or behind it.


Will a 1996 or 1997 or 1998 Toyota Camry hood fit on 1999 Toyota Camry.?

1997 and 1998 will fit on 1999. 1996 is a different model.