#1 should be labeled on the cap, and it is clockwise.
it turns clockwise while all the other planets turn counter-clockwise look at this example key;venus is number 2 clockwise ------------- counter-clockwise ------------------------ venus mars earth mercury Jupiter Saturn uranuas neptune Pluto
First, spin the dial clockwise a few times to reset the lock. Then continue turning clockwise until you reach the first number of the combination. Then spin the dial counter-clockwise one full revolution so you are back at the first number. Then continue turning counter-clockwise until you reach the second number. Then turn the dial clockwise until you get to the third number (do not spin the extra revolution this time). At this point, you should be able to pull the lock open.
To open a Brinks lock you first have to set the lock on zero. Next you turn it clockwise four complete turns, then do it once more stopping on the first number of the combination. Then turn the dial counter clockwise for two turns, do it once more and stop on the second number, turn the dial clockwise twice stopping on the third number of the combination, finally turn counter clockwise to the fourth number. The lock should then open.
The firing order is 153624 with the number 1 being closest to the FIREWALL on the engine. Very important when timing the car. The distributer runs counter clockwise, and the numder 1 position on the distributor is to the left of the top retaining screw or clip when standing at the side of the car looking directly at the distributor. As far as I'm aware, this holds true for the xj6 1981-86. Hope this helps.
It is the counter that tells you the position of the numbers in the sequence: the first, second and so on.
The simplest answer is turn counter clockwise to remove, turn clockwise to install. If you are asking for specific directions on a certain vehicle, you will need to ask a NEW question with info such as year, make, model, and a description of the problem.The simplest answer is turn counter clockwise to remove, turn clockwise to install. If you are asking for specific directions on a certain vehicle, you will need to ask a NEW question with info such as year, make, model, and a description of the problem.
The spark plug firing order on your 400 ( 6.6 L ) is ( 1-3-7-2-6-5-4-8 ) The distributor rotor rotates COUNTER CLOCKWISE The # 1 position on the cap ( should be marked ) and the cap is installed with the # 1 position facing to the rear and slightly towards drivers side of engine
A 60-degree clockwise movement of the hour hand from the 5 o'clock position - would place it over the number 7.
Firing order is 1-3-7-2-6-5-4-8 Number one plug is located passenger side front of engine. Distributor rotates counter clockwise. 1-3-7-2-6-5-4-8 distributer turns counter clockwise
Standing in front looking at the distributor cap, number one would be at the 5 O'Clock position, from there clockwise it goes, 1, 6, 5, 4, 3, 2.
The distributor cap is installed with the # 1 position towards the engine , and slightly towards the drivers side of the engine . firing order is 1-5-4-2-6-3-7-8 , the distributor rotor rotates COUNTER CLOCKWISE
firing order 1 3 4 2 wires go clockwise position: 2 1 4 3 firing order 1 3 4 2 wires go clockwise position: 2 1 4 3 firing order 1 3 4 2 wires go clockwise position: 2 1 4 3