On my brother's 1995 Jeep Cherokee, as well as my 1992 Jeep Cherokee (Both with the 4.0L engine) the OBD1 connector is located in the engine compartment on the left side, between the air cleaner and the computer module. It's a funny looking plug, not the standard OBD connector.
It would be helpful to tell us what kind of Jeep you have. But I believe 1995 Jeeps had OBD1. Anything older than 1996 is OBD1. the port on the jeep is located under the dash at the column it should be a little black box thing the about size of a match box that you can take the cover off of to locate the port.
OBD1
The 1993 Jeep Wrangler as are all modern vehicles is equipped with the on board diagnostic system and access port. The OBD Series I connector port will be located on the right front side of the vehicle below the steering wheel.
obd not available until 1996
No, different communication protocol.
A 1995 Jeep uses R134a, not R12. The caps are grey or black.
Under the dash on the driver side. It is a six wire probably blue connector.
There should be an " EEC TEST " connection in your engine compartment , near the battery / power distribution box
Hello, Jamison here, I can't recall, But if you are using A scanning tool like a M2500 and it sounds like you are, It will tell you where it is,,,,,,,,, Hope I did'nt mess you up,,,,,,,,,,,,,,,,Jamison.
Yes, it is under the hood near the battery.
The 1988 Jeep Cherokee air conditioning low pressure port is located on the air conditioning compressor. The low pressure port will be on the right hand side of the compressor.
The 95 Conti has no OBD1 plug. The vehicle is equipped with the OBD2 system with the port under the steering wheel.