Top Answer
User Avatar
Wiki User
Answered 2014-03-14 09:22:12

There is no OBD-2 on that model... They first OBD 2 Wrangler was the 1997 model.

The 1995 connector is under the hood.

User Avatar

Your Answer

Related Questions

The 2002 Jeep Wrangler OBD 2 port is below instrument panel, left of brake pedal

No. 1995 was OBD-I controls, SBEC. 1998 was OBD-II controls, JTEC.

No, that was standard on 96 and up, you will have OBD1

The OBD port is under the dash on the driver side.

The 1993 Jeep Wrangler as are all modern vehicles is equipped with the on board diagnostic system and access port. The OBD Series I connector port will be located on the right front side of the vehicle below the steering wheel.

Yes, it is under the hood near the battery.

a 1995 grand Cherokee is obd 1 compliant, The diagnostic connecter is under the hood. It is a black square connector.

The OBD port is under the dash on the driver side.

i am unable to locate the under dash obd port i my 2012 jeep patroit

It is OBD I, not OBD II, the connector is under the hood.

The OBD connector is under the dash on the driver side.

A 1995 Bronco does not have an OBD-II port - OBD-II started on 1996 vehicle. 1995 Brocno would have OBD-I. The connector should be under the hood, on the inside wall of the driver's side fender near the firewall.

The 2000 Jeep Cherokee OBD 2 port is on rear of lower left edge of dash

It would be helpful to tell us what kind of Jeep you have. But I believe 1995 Jeeps had OBD1. Anything older than 1996 is OBD1. the port on the jeep is located under the dash at the column it should be a little black box thing the about size of a match box that you can take the cover off of to locate the port.

The 1995 vehicle should be ODB I. The OBD I connector should be under the hood in the engine compartment.

On my brother's 1995 Jeep Cherokee, as well as my 1992 Jeep Cherokee (Both with the 4.0L engine) the OBD1 connector is located in the engine compartment on the left side, between the air cleaner and the computer module. It's a funny looking plug, not the standard OBD connector.

It is under the dash on the driver side.

Trouble code P0432 means: Catalyst Efficiency Fault (Bank 2)

Probably not, very few 94's were obd2.

No but, the ignition has to be on (KOEO, Key On Engine Off).

The obd 1 port is next to the battery

Under the hood, near the battery.

It has OBD 2, connector is under the dash on the left side.

under dash on drivers side to the right of the steering column

Copyright ยฉ 2021 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.